Broad Band Terminated Dipoles (BBTD), Tilted Terminated Fold Dipoles (T2FD) and Balanced Termination Folded Dipole BTFD) antennas can be designed to cover a large range of frequencies between 1.8 30 MHz. Longer length antennas generally provide better low frequency efficiency but take up a larger footprint of land. One BBTD that has worked well at the AK6R antenna farm is shown below. Many other designs are available and can be found at www.HFLINK.COM as well as other internet sites. Your mileage may vary using this antenna, but as a general coverage antenna for ham and shortwave broadcast, the simplicity can’t be beat even though an individual dipole on a specific band may out perform this broad band dipole. Palomar Engineers has all the parts you need to build this antenna, so why not give it a try?
Depending on the source of the antenna design, different value baluns are specified. Our Bullet(TM) baluns in ratios of 9:1, 12:1 and 16:1 are excellent for this type of antenna as they are broadband from 1.8-61 MHz and will take up to 500 watts PEP.
Ferrite Snap On, ID = .514in/13.1 mm, 10 Pack for troubleshooting unknown RFi frequencies
Use Mix 31 for 1-300 MHz - 4 pieces
Use Mix 61 for 200- 2000 MHz - 3 pieces
Use Mix 75 for150 KHz-10 MHz - 3 pieces
At last a troubleshooter's ferrite kit that works from 150 KHz to 2 H=GHZ. Now you can suppress RFi from unknown frequency ranges with a full spectrum of ferrite cores that have a 1/2" ID large enough for multiple turns of many common data and signal wires. Try 1 mix and see if it has an effect and if not then try another until you suppress the unknown frequencies. Or use them all to provide protection across a broad frequency range. 3 ferrite cores provide at least 500 ohms in the frequency band to give a measurable difference in RFI and noise suppression.
Square or Hex sided depending upon inventory stock
Likewise Termination Resistor values vary from 500-1250 ohms and we have a good selection shown HERE: