Broad Band Terminated Dipoles (BBTD), Tilted Terminated Fold Dipoles (T2FD) and Balanced Termination Folded Dipole BTFD) antennas can be designed to cover a large range of frequencies between 1.8 30 MHz. Longer length antennas generally provide better low frequency efficiency but take up a larger footprint of land. One BBTD that has worked well at the AK6R antenna farm is shown below. Many other designs are available and can be found at www.HFLINK.COM as well as other internet sites. Your mileage may vary using this antenna, but as a general coverage antenna for ham and shortwave broadcast, the simplicity can’t be beat even though an individual dipole on a specific band may out perform this broad band dipole. Palomar Engineers has all the parts you need to build this antenna, so why not give it a try?
Depending on the source of the antenna design, different value baluns are specified. Our Bullet(TM) baluns in ratios of 9:1, 12:1 and 16:1 are excellent for this type of antenna as they are broadband from 1.8-61 MHz and will take up to 500 watts PEP.
All coax I/O and control lines and AC/DC power line for high end amplifiers with multiple RF inputs and outputs, control/keying/frequency I/O.
Includes typical amps such as Yaesu Quadra, Icom PW1, ACOM, ALPHA,Tokyo High Power, Palstar, ETC.
Included are the following chokes and installation guidelines to suppress RFI in and out:
Deluxe Kit:
RF Input (1x):Ring Filter (1.4” ID) – 5-9 turns of RG-58/8X size through center
RF Output (3x):Snap On Filter (1” ID) – 3 turns of coax cable through center
Relay/ALC Cables (1x):Snap On Filter (3/4” ID) – multiple turns through center, both cables in same ferrite
Band Control cable:Snap On Filter (3/4” ID)- multiple turns through filter
AC/DC Power:Snap On Filter (1” ID) – 3 turns of power cord through center
You get 1.4" ID Ring x 1, 1" ID snap on x 4, 3/4" ID snap on x 2 with each kit.
STOP THE RFI NOW WITH THIS SIMPLE TO INSTALL KIT
Likewise Termination Resistor values vary from 500-1250 ohms and we have a good selection shown HERE: