Broad Band Terminated Dipoles (BBTD, T2FD)

Broad Band Terminated Dipoles (BBTD), Tilted Terminated Fold Dipoles (T2FD) and Balanced Termination Folded Dipole BTFD) antennas can be designed to cover a large range of frequencies between 1.8 30 MHz.  Longer length antennas generally provide better low frequency efficiency but take up a larger footprint of land.   One BBTD that has worked well at the AK6R antenna farm is shown below.  Many other designs are available and can be found at www.HFLINK.COM as well as other internet sites.  Your mileage may vary using this antenna, but as a general coverage antenna for ham and shortwave broadcast, the simplicity can’t be beat even though an individual dipole on a specific band may out perform this broad band dipole.  Palomar Engineers has all the parts you need to build this antenna, so why not give it a try?

BBTD at AK6R 1024x726 - Broad Band Terminated Dipoles (BBTD, T2FD)

 

Depending on the source of the antenna design, different value baluns are specified.  Our Bullet(TM) baluns in ratios of 9:1, 12:1 and 16:1 are excellent for this type of antenna as they are broadband from 1.8-61 MHz and will take up to 500 watts PEP.

564739041 - Broad Band Terminated Dipoles (BBTD, T2FD)
+3

Home Theater System RFI Kit for AC Powered Sub-Woofers Only - 5 filters

RFI-HTS-SW
$29.95
In stock
1
Product Details
MPN: RFI-HTS-SW
Type: NEW
Country/Region of Manufacture: USA
Filter Power Rating (PEP watts): not applicable
RFI Suppression Range (MHz): 1-300 MHz

This sub-woofer RFi kit is specifically designed to suppress audio interference triggered by Radio Frequency Interference problems from AM, FM, CB and Ham radio stations AND to minimize the interference to nearby electronics caused by a sub-woofer without magnetic shielding (Velodyne, Hartley, Hsu, etc). The ferrite filters are selected to suppress RFI from 1 to 300 MHz. The filters are easy to install, don’t require modification of the protected equipment and work in almost all cases.

What is included in the kit?

The RFI-HTS-SW kit contains a a ring filter for the AC power cord to the sub-woofer and 4 snap-on filters for the speaker wires (either for audio pass through to main speakers or direct line out to the sub-woofer).

Tech Note: This kit is INCLUDED in the full home theater RFI Kit (part #RFI-HTS) and you do not have to purchase a separate RFI kit for the sub-woofer.

Save this product for later
Display prices in: USD

Likewise Termination Resistor values vary from 500-1250 ohms and we have a good selection shown HERE: