Broad Band Terminated Dipoles (BBTD), Tilted Terminated Fold Dipoles (T2FD) and Balanced Termination Folded Dipole BTFD) antennas can be designed to cover a large range of frequencies between 1.8 30 MHz. Longer length antennas generally provide better low frequency efficiency but take up a larger footprint of land. One BBTD that has worked well at the AK6R antenna farm is shown below. Many other designs are available and can be found at www.HFLINK.COM as well as other internet sites. Your mileage may vary using this antenna, but as a general coverage antenna for ham and shortwave broadcast, the simplicity can’t be beat even though an individual dipole on a specific band may out perform this broad band dipole. Palomar Engineers has all the parts you need to build this antenna, so why not give it a try?
Depending on the source of the antenna design, different value baluns are specified. Our Bullet(TM) baluns in ratios of 9:1, 12:1 and 16:1 are excellent for this type of antenna as they are broadband from 1.8-61 MHz and will take up to 500 watts PEP.
This is a generic linear amplifier RFI kit for DC powered amplifiers. Works on many popular amplifiers including:
Specially designed for the Elecraft KPA500 linear amplifier used with the KX3 and similar transceivers.
Included are the following chokes and installation guidelines:
Included are the following chokes and installation guidelines:
RF Input:F240 ring – 5-9 turns of RG-58 size through center
RF Output:FSB-1 (Big Clamp on) – 3 turns of RG-8 size cable
PA KEY Cable:FSB-1/2 – multiple turns through choke – ½” diameter hole
AC Power Line:F240 ring – 5-6 turns through center
Computer/RS232/AUX Cable:FSB-1/2 – multiple turns through choke – ½” diameter hole
Also make sure you connect a good RF ground to the amplifier ground post.
Likewise Termination Resistor values vary from 500-1250 ohms and we have a good selection shown HERE: