Broad Band Terminated Dipoles (BBTD), Tilted Terminated Fold Dipoles (T2FD) and Balanced Termination Folded Dipole BTFD) antennas can be designed to cover a large range of frequencies between 1.8 30 MHz. Longer length antennas generally provide better low frequency efficiency but take up a larger footprint of land. One BBTD that has worked well at the AK6R antenna farm is shown below. Many other designs are available and can be found at www.HFLINK.COM as well as other internet sites. Your mileage may vary using this antenna, but as a general coverage antenna for ham and shortwave broadcast, the simplicity can’t be beat even though an individual dipole on a specific band may out perform this broad band dipole. Palomar Engineers has all the parts you need to build this antenna, so why not give it a try?
Depending on the source of the antenna design, different value baluns are specified. Our Bullet(TM) baluns in ratios of 9:1, 12:1 and 16:1 are excellent for this type of antenna as they are broadband from 1.8-61 MHz and will take up to 500 watts PEP.
Your rotor cable and control box can cause RFI into your radio station and you need to suppress common mode RFI induced into the cable from your antennas. In many cases the rotor cable acts as an unintended counterpoise for your rotated antennas and can cause weird SWR issues since the control cables become part of the antenna,
The SOLUTION is simple: isolate the cable from RFI by adding the Palomar RFI kit for antenna rotors. Add 3 snap on filters near the rotor and another 3 snap on filters at the rotor control box and a ring filter for AC powered rotor control boxes to suppress RFI common mode currents that can affect the antenna SWR and radiation patterns. In addition, these filters may also help reduce station receiver noise since many rotors are connected to the station ground and the rotor cable acts as an additional receiving antenna.
Isolating the rotor cable works on the same principal as isolating coax cable - keep the TRANSMIT signal on the antenna by proving a feed line choke at the rotor itself and keep noise out of the station on RECEIVE by choking the cable at the rotor control box ( by suppressing noise pickup on the cable).
Kit includes 7 filters -six 1/2" snap on filters for the cable and a ring filter for the AC/DC power supply for the control box. Simple to install and cheap insurance to solve both the TRANSMIT and RECEIVE issues caused by rotor control systems.
Likewise Termination Resistor values vary from 500-1250 ohms and we have a good selection shown HERE: