After many requests we have created a compact, special balun for single band loop (Sky loop or Delta loop) antennas with specific dimension that present a feedpoint of 70-75 ohms. The CB-1.5-1-1500/5000 is a CUBE(TM) enclosure containing a multi-core, broadband 1.5:1 impedance transformer (50 ohm coax input to 75 ohm balanced output) in series with a 1:1 current balun for extra common mode current choking to keep RF current off the outside of the coax braid and on the antenna where it belongs. The extra choking action also means that the coax feed line will not act as a radiator causing unnecessary RF interference (RFI). Rated for full 1500 watts PEP and 1500 watts CW (ICAS), 1KW Digital. 1.8Mhz – 61 MHz.
CB-1.5-1-1500EB is housed in a 4” x 4” x 2” waterproof housing with SO-239 input and stainless steel eye bolts on the side for ease of connection to your wire antenna (or top studs as desired). Top eye bolt acts as an antenna hoist. Also available with top studs for post or wall mounting (Model # CB-1.5-1-1500/5000TS). 5KW models are in a 4 " x 4" x 4" housing.
Loop antennas should be cut for 1005/F(MHz) in total length, where F (MHz) is the lowest frequency to be used. For 3.5MHz this equates to 288 foot perimeter (square, delta, multi-side ok). Vertiucal loops with pointy side up and longer bases and fed 1/4 wavelength down one side have a feedpoint impedance near 75 ohms for which this balun is well suited. A very good DX antenna!
For unbalanced 50 ohm input to unbalanced 75 ohm output use the CU-1.5-1500 or CU-1.5-5000.
Display Note: Product picture is 2:1 balun, 1:1 Unun but actual delivered product is CB/CU-1.5-1-1500/5000 as selected.
AM broadcast transmits on a low frequency with large antennas. Consequently it takes a large antenna to receive the signals. Typical “antennas” are AC house wiring, phone lines, long satellite or cable TV cables, DSL/CAT5 lines running between rooms, etc. The device wires that connect to these “antennas” need to be choked with as many turns through the ferrite as possible. Some installation examples are shown below on this page.
For AC/ DC power cords and coax cables the F240-77 (2.4″ OD, 1.4″ ID) “Donut” toroid is the most popular. Also available are smaller toroid donuts and Mix 77 beads. Shown below is a graph with 8, 10, and 12 turns through the toroid – obviously more turns has higher choking impedance. Mix 77 toroid products are HERE and Mix 77 small beads (for small wires) are HERE
F240-77 Turns Comparison from .1 – 8.1 Mhz
Shown below is a graph of frequency response verses choking magnitude for a F240-77 in the AM Broadcast band for a 12 turn coil around the toroid. (Same info as above but different frequency range).
F240-77 Choking Impedance in AM Broadcast Band
Typical Installations for Donut/Ring Toroids
 AC Cable on F-240 Toroid – 6 turns |
 Ethernet Cable on F-240 Toroid – 7 turns |
 Audio or Mic cable on F240- 12 turns |
Extra Mix 75 Snap On Beads HERE – VERY effective for AM Broadcast RFI