All coax I/O and control lines and AC/DC power line for high end amplifiers with multiple RF inputs and outputs, control/keying/frequency I/O.
Includes typical amps such as Yaesu Quadra, Icom PW1, ACOM, ALPHA,Tokyo High Power, Palstar, ETC.
Included are the following chokes and installation guidelines to suppress RFI in and out:
Deluxe Kit:
RF Input (2x):Ring Filter (1.4” ID) – 5-9 turns of RG-58/8X size through center
RF Output (4x):Snap On Filter (1” ID) – 3 turns of coax cable through center
Relay Cable (2x):Snap On Filter (1/2” ID) – multiple turns through center
ACC1/ACC2 (2x):Snap On Filter (1/2” ID)- multiple turns through filter for each ACC
Transceiver Control/Remote CIV (1X):multiple turns of both cables through filter
AC/DC Power:Snap On Filter (1” ID) – 3 turns of power cord through center
You get 1.4" ID Ring x 2, 1" ID snap on x 5, 1/2" ID snap on x 5 with each kit.
FREE USA SHIPPING!
AM broadcast transmits on a low frequency with large antennas. Consequently it takes a large antenna to receive the signals. Typical “antennas” are AC house wiring, phone lines, long satellite or cable TV cables, DSL/CAT5 lines running between rooms, etc. The device wires that connect to these “antennas” need to be choked with as many turns through the ferrite as possible. Some installation examples are shown below on this page.
For AC/ DC power cords and coax cables the F240-77 (2.4″ OD, 1.4″ ID) “Donut” toroid is the most popular. Also available are smaller toroid donuts and Mix 77 beads. Shown below is a graph with 8, 10, and 12 turns through the toroid – obviously more turns has higher choking impedance. Mix 77 toroid products are HERE and Mix 77 small beads (for small wires) are HERE
F240-77 Turns Comparison from .1 – 8.1 Mhz
Shown below is a graph of frequency response verses choking magnitude for a F240-77 in the AM Broadcast band for a 12 turn coil around the toroid. (Same info as above but different frequency range).
F240-77 Choking Impedance in AM Broadcast Band
Typical Installations for Donut/Ring Toroids
 AC Cable on F-240 Toroid – 6 turns |
 Ethernet Cable on F-240 Toroid – 7 turns |
 Audio or Mic cable on F240- 12 turns |
Extra Mix 75 Snap On Beads HERE – VERY effective for AM Broadcast RFI