Iron Powder Cores

Troubleshooter's Ferrite Pack Mix 31, 75, 61, 1/2" ID, RFI Range 150 KHz-2000 MHz, 10 Pieces

SKU TFP-1/2-10
In stock
Product Details

Ferrite Snap On, ID = .514in/13.1 mm, 10 Pack for troubleshooting unknown RFi frequencies

Use Mix 31 for 1-300 MHz - 4 pieces

Use Mix 61 for 200- 2000 MHz - 3 pieces

Use Mix 75 for150 KHz-10 MHz - 3 pieces

At last a troubleshooter's ferrite kit that works from 150 KHz to 2 H=GHZ. Now you can suppress RFi from unknown frequency ranges with a full spectrum of ferrite cores that have a 1/2" ID large enough for multiple turns of many common data and signal wires. Try 1 mix and see if it has an effect and if not then try another until you suppress the unknown frequencies. Or use them all to provide protection across a broad frequency range. 3 ferrite cores provide at least 500 ohms in the frequency band to give a measurable difference in RFI and noise suppression.

Square or Hex sided depending upon inventory stock

Save this product for later

Iron Cores 150x150 - Iron Powder CoresIron powder cores are more stable than ferrites and do not saturate as easily so they are best for tuned circuits, filters, and high power inductors. They come in different “Mixes” for use at different frequencies. For best “Q” use the Mix specified for your frequency.To find the number of turns to give the desired inductance for your coil use the formula below:


Turns = 100 x iron core formula 300x14 - Iron Powder Cores

Toroid Dimensions

tcolorcode - Iron Powder Corestcore - Iron Powder Cores


To order specify core size and mix (e.g. T200A-2). Available in sizes that have µH per 100 turns shown in table.

All iron powder cores are special orders.  Please allow one week for shipment after order received.

The iron powder cores shown in the above tables are primarily used for either high power feed line chokes for common mode current reduction or for 4:1  and 9;1 very high power transmission line transformers.

For high power feed line chokes, choose the inside diameter of the iron powder core closest to the transmission line outside diameter and use 6-20 cores at the junction with the antenna feed.

For 4:1 (50/200 or 75/300 ohm) transmission line transformers in the range of 1.8-30 Mhz, select the size appropriate for the power level as follows:

T200A x 2 = 1.5KW

T300A x 2 = 2.5KW

T400A x 2 = 5KW

Use Mix 2 for all the above transmission line transformers.  Fully assembled and enclosed units are available for each of the power levels.  Click HERE for information.

4:1 transmission line transformers using iron powder cores are typically used for ladder line to 50 ohm coax connections

For .1 – 2 Mhz wide band transformers use Mix 26 which has a higher permeability and requires less turns to achieve a given inductance. Mix 2 has almost constant permeability from 1-30 Mhz.  Mix 26 has an initial permeability of 75 at .1 Mhz and gradually decreases to about 10 at 30 Mhz.  For high power AM broadcast range (.5-1.7 Mhz) transformer, use Mix 26 to reduce the turn count.

Minimum order for iron powder cores is $50  

Shipping on larger cores in quantity may be more than $10 – email/call for quote.