Got an electronic interference problem on your boat or RV? Do you hear HUM-BUZZ-NOISE when you use the fish finder/radar/GPS/Generator or hear your voice on the stereo speakers when you transmit on the radio? Maybe you heard buzzing or humming when you turned on the battery charger/inverter/generator – any of these symptoms indicate you have RFI issues on your boat or RV and you need to stop it or the HUM-BUZZ-NOISE may drive you nuts! But you don’t have to worry – We got the fix for you – lots of filters, all in a small box, that are easy to install on the wires of your electronic stuff that is bothered by the RFI. If you have RFI, you need this kit: Boat Owner’s Electronic Interference Suppression Kit Use this filter kit to suppress interference noise between electronic devices on your boat including: radar, fish finders, audio/video systems, inverter noise, solar controllers, vhf radio, marine/ham radio, auto pilots, electronic gauges, PA systems, and many other electronic devices. What is included: A total of 17 Ferrite Ring/Snap-On Filters Ring: 1.4” ID x 6, Snap on: 3/8” ID x 6, 1/2” ID x 5 Mix 31 Interference Range: 1-300 MHz
Iron powder cores are more stable than ferrites and do not saturate as easily so they are best for tuned circuits, filters, and high power inductors. They come in different “Mixes” for use at different frequencies. For best “Q” use the Mix specified for your frequency.To find the number of turns to give the desired inductance for your coil use the formula below:
Turns = 100 x 
Toroid Dimensions
To order specify core size and mix (e.g. T200A-2). Available in sizes that have µH per 100 turns shown in table.
All iron powder cores are special orders. Please allow one week for shipment after order received.
The iron powder cores shown in the above tables are primarily used for either high power feed line chokes for common mode current reduction or for 4:1 and 9;1 very high power transmission line transformers.
For high power feed line chokes, choose the inside diameter of the iron powder core closest to the transmission line outside diameter and use 6-20 cores at the junction with the antenna feed.
For 4:1 (50/200 or 75/300 ohm) transmission line transformers in the range of 1.8-30 Mhz, select the size appropriate for the power level as follows:
T200A x 2 = 1.5KW
T300A x 2 = 2.5KW
T400A x 2 = 5KW
Use Mix 2 for all the above transmission line transformers. Fully assembled and enclosed units are available for each of the power levels. Click HERE for information.
4:1 transmission line transformers using iron powder cores are typically used for ladder line to 50 ohm coax connections
For .1 – 2 Mhz wide band transformers use Mix 26 which has a higher permeability and requires less turns to achieve a given inductance. Mix 2 has almost constant permeability from 1-30 Mhz. Mix 26 has an initial permeability of 75 at .1 Mhz and gradually decreases to about 10 at 30 Mhz. For high power AM broadcast range (.5-1.7 Mhz) transformer, use Mix 26 to reduce the turn count.
Minimum order for iron powder cores is $50
Shipping on larger cores in quantity may be more than $10 – email/call for quote.