5:1 Baluns/Ununs

5:1 CUBE™ Unun – Model CU-5-1500 (50:250 Ohm, 1.8-61 MHz, 1.5KW PEP)

Application. For traveling wave, end fed or portable 20-31 foot vertical antennas the 5:1 unun makes a good transformer for converting 50 ohm coax to a 250 ohm feed point. If you use the antenna on multiple bands, the feed point impedance may not always be 250 ohms and use of the unun at high (>350 ohms) or low (<100 ohms) will require reduced power input or the unun may have its power ratings exceeded and damage to the unun may occur. The (5:1 conversion ratio will change for loads other than 250 ohms unbalanced.

Typical application:

CU 5 1500 antenna - 5:1 Baluns/Ununs

Also available as a balanced output – CB-5-1500

3540561917 - 5:1 Baluns/Ununs
+3

Termination Resistor, 500 Ohm Non-Inductive for T2FD, BBTD, Rhombic, 1-61 MHz, 600 Watts

TR-500-600
$99.95
In stock
1
Product Details

Broadband, Non-Inductive Termination Resistor load used on many terminated antenna types such as T2FD, Broadband Terminated Dipole (BBTD), Rhombics and others

Resistive Value: 500 ohms (+/- 10%)

SSB (25% duty cycle) rating in Watts: 600

CW/FT8 (50% duty cycle) in watts: 400

Length (tip to tip) Inches: 14"

Width inches: 3"

Inductance < 20 nH (1-61 MHz)


Internal Resistance Wattage: 200 watts

If you need more power rating, consider putting two TR-1000-600 resistors in parallel for a total of 1200 watts at 500 ohms.

Many designs for BBTD antennas using termination resistors at HFLINK.COM

Excellent BBTD Install info by K1FU

Save this product for later
Display prices in: USD