5:1 Baluns/Ununs

5:1 CUBE™ Unun – Model CU-5-1500 (50:250 Ohm, 1.8-61 MHz, 1.5KW PEP)

Application. For traveling wave, end fed or portable 20-31 foot vertical antennas the 5:1 unun makes a good transformer for converting 50 ohm coax to a 250 ohm feed point. If you use the antenna on multiple bands, the feed point impedance may not always be 250 ohms and use of the unun at high (>350 ohms) or low (<100 ohms) will require reduced power input or the unun may have its power ratings exceeded and damage to the unun may occur. The (5:1 conversion ratio will change for loads other than 250 ohms unbalanced.

Typical application:

CU 5 1500 antenna - 5:1 Baluns/Ununs

Also available as a balanced output – CB-5-1500

1108290796 - 5:1 Baluns/Ununs
+3

Termination Resistor, 400 Ohm Non-Inductive for Terminated Vee, T2FD, BBTD, Rhombic, V-Beam, 1-61 MHz, 600 Watts

TR-400-600
$99.95
In stock
1
Product Details

Broadband, Non-Inductive Termination Resistor load used on many terminated antenna types such as Terminated Vee (see picture), T2FD, Broadband Terminated Dipole (BBTD), Rhombics, V-Beams and others

Resistive Value: 400 ohms (+/- 10%)

SSB (25% duty cycle) rating in Watts: 600

CW/FT8 (50% duty cycle) in watts: 300

Length (tip to tip) Inches: 11 1/4"

Width inches: 2 1/4"

Inductance < 20 nH (1-61 MHz)

Internal Resistance Wattage: 150 watts

Antenna Note: For terminated V antenna shown, use a 16:1 + 1:1 hybrid transformer to match the 50 ohms to 800 (400 + 400) in the antenna "legs"


Save this product for later
Display prices in: USD