5:1 CUBE™ Unun – Model CU-5-1500 (50:250 Ohm, 1.8-61 MHz, 1.5KW PEP)
Application. For traveling wave, end fed or portable 20-31 foot vertical antennas the 5:1 unun makes a good transformer for converting 50 ohm coax to a 250 ohm feed point. If you use the antenna on multiple bands, the feed point impedance may not always be 250 ohms and use of the unun at high (>350 ohms) or low (<100 ohms) will require reduced power input or the unun may have its power ratings exceeded and damage to the unun may occur. The (5:1 conversion ratio will change for loads other than 250 ohms unbalanced.
Typical application:
Also available as a balanced output – CB-5-1500
RG-400 Coax Jumper Cable with PL-259's on each end - 6 inch pigtail, Double Shield, High PowerProduct DetailsThis cable is 50 ohm and short 6 inch pigtail double shielded with foil and braid and PL-259 connectors on each end. All the connections inside are soldered and the cable is made of copper conductors with coax having PVC jacket. RG400 is generally useful up to 5000 watts PEP at HF frequencies below 30 MHz. Greater power capability and frequency range than RG-8X, yet similar physical size.
Use for short jumper for Palomar Engineers Noise Filters like CMNF-500-50 or SWR meter, etc.
** Our Customers also used this RG400 Coax in longer sizes to make ham radio common mode chokes up to 5KW PEP
Physical Specifications:
• Inner conductor: Silver Plated Copper, Diameter: 19x0.203mm
• Dielectric/Insulation: PTFE, Diameter: 2.95mm
• Outer Conductor/Double-Shield: silver plated copper double braid , Diameter: 3.95mm
• Jacket: FEP, Diameter: 4.95mm
Electrical Specifications:
• Nom. Capacitance Conductor to Shield: 105 pF/m
• Nom. Characteristic Impedance: 50 Ω(ohm)
• Nom. Velocity of Propagation: 70%
• Min. Bend Radius(Install): 25mm
• Voltage Rating: 1900 VMS
• Max. Operating Frequency: 12400 MHz
• Operating Temperature Rating: -55℃ ～ +200℃
Attenuation:
• 100 MHz : 0.144 dB/m
• 400 MHz : 0.295 dB/m
• 1,000 MHz : 0.482 dB/m
• 5,000 MHz : 1.184 dB/m
• 11,000 MHz : 1.899 dB/m
This cable is 50 ohm and short 6 inch pigtail double shielded with foil and braid and PL-259 connectors on each end. All the connections inside are soldered and the cable is made of copper conductors with coax having PVC jacket. RG400 is generally useful up to 5000 watts PEP at HF frequencies below 30 MHz. Greater power capability and frequency range than RG-8X, yet similar physical size.
Use for short jumper for Palomar Engineers Noise Filters like CMNF-500-50 or SWR meter, etc.
** Our Customers also used this RG400 Coax in longer sizes to make ham radio common mode chokes up to 5KW PEP
Physical Specifications:
• Inner conductor: Silver Plated Copper, Diameter: 19x0.203mm
• Dielectric/Insulation: PTFE, Diameter: 2.95mm
• Outer Conductor/Double-Shield: silver plated copper double braid , Diameter: 3.95mm
• Jacket: FEP, Diameter: 4.95mm
Electrical Specifications:
• Nom. Capacitance Conductor to Shield: 105 pF/m
• Nom. Characteristic Impedance: 50 Ω(ohm)
• Nom. Velocity of Propagation: 70%
• Min. Bend Radius(Install): 25mm
• Voltage Rating: 1900 VMS
• Max. Operating Frequency: 12400 MHz
• Operating Temperature Rating: -55℃ ～ +200℃
Attenuation:
• 100 MHz : 0.144 dB/m
• 400 MHz : 0.295 dB/m
• 1,000 MHz : 0.482 dB/m
• 5,000 MHz : 1.184 dB/m
• 11,000 MHz : 1.899 dB/m
