5:1 CUBE™ Unun – Model CU-5-1500 (50:250 Ohm, 1.8-61 MHz, 1.5KW PEP)
Application. For traveling wave, end fed or portable 20-31 foot vertical antennas the 5:1 unun makes a good transformer for converting 50 ohm coax to a 250 ohm feed point. If you use the antenna on multiple bands, the feed point impedance may not always be 250 ohms and use of the unun at high (>350 ohms) or low (<100 ohms) will require reduced power input or the unun may have its power ratings exceeded and damage to the unun may occur. The (5:1 conversion ratio will change for loads other than 250 ohms unbalanced.
Typical application:
Also available as a balanced output – CB-5-1500
Household RFI Kit - Suppress Noise, Reduce RFI to Household Electronics - 10 FiltersProduct DetailsMPN: RFI-HouseholdCountry/Region of Manufacture: United StatesFilter Power Rating (PEP watts): n/aChoking Impedance (ohms): 300-5000 ohms with multi-turnRFI Suppression Range (MHz): 1-300 MHz# Ferrite Filters: 10Typical Use:: household electronicsGENERIC HOUSEHOLD RADIO FREQUENCY INTERFERENCE (RFI) KIT
The RFI kit is designed to cure most household RFI problems. It contains ferrite toroids and beads selected to eliminate RFI from .1 to 300 MHz.The beads are easy to use, don’t require modification of the protected equipment and work in almost all cases, even when plug-in filters fail.
What is in the kit? Three 1/2" ID snap on beads, three 1/4" snap on beads, 3 wall wart filter rings to suppress noise and interference and a large 1.4" ID ring for AC power cord installation on RFI prone equipment like computers, Home Theater Systems, telephones, etc.
Plus full instructions in the RFI Tip
Sheet. A $49.50 retail value if purchased separately.
GENERIC HOUSEHOLD RADIO FREQUENCY INTERFERENCE (RFI) KIT
The RFI kit is designed to cure most household RFI problems. It contains ferrite toroids and beads selected to eliminate RFI from .1 to 300 MHz.The beads are easy to use, don’t require modification of the protected equipment and work in almost all cases, even when plug-in filters fail.
What is in the kit? Three 1/2" ID snap on beads, three 1/4" snap on beads, 3 wall wart filter rings to suppress noise and interference and a large 1.4" ID ring for AC power cord installation on RFI prone equipment like computers, Home Theater Systems, telephones, etc.
Plus full instructions in the RFI TipSheet. A $49.50 retail value if purchased separately.