5:1 CUBE™ Unun – Model CU-5-1500 (50:250 Ohm, 1.8-61 MHz, 1.5KW PEP)
Application. For traveling wave, end fed or portable 20-31 foot vertical antennas the 5:1 unun makes a good transformer for converting 50 ohm coax to a 250 ohm feed point. If you use the antenna on multiple bands, the feed point impedance may not always be 250 ohms and use of the unun at high (>350 ohms) or low (<100 ohms) will require reduced power input or the unun may have its power ratings exceeded and damage to the unun may occur. The (5:1 conversion ratio will change for loads other than 250 ohms unbalanced.
Typical application:
Also available as a balanced output – CB-5-1500
Elecraft KPA1500 HF Linear Amplifier RFI Kit - 15 Filters for RF In/Out, AC Power, PA KEY, Computer Control/AUX/RS232Product DetailsMPN: RFI-ELECRAFT-KPA1500Type: NewCountry/Region of Manufacture: United StatesFilter Power Rating (PEP watts): coax cable limitRFI Suppression Range (MHz): 1-300 MHz# Ferrite Filters: 15Typical Use:: AC power, RF In/out, I/O control cablesKPA1500
This RFI Kit Includes are the following filters and installation guidelines:
RF Input:F240 ring – 5-9 turns of RG-58/8X size through center
RF Output:# 1 - FSB31-1 (Big Clamp on) – 3 turns of RG-8 size cable
RF Output:# 2 - FSB31-1 (Big Clamp on) – 3 turns of RG-8 size cable
PA KEY Cable: - FSB31-1/2 – multiple turns through choke – ½” diameter hole
DC Power Line: - FSB31-1 (Big Clamp on) – 2 turns through center
AC Line of DC Power Supply: - FSB31-1 (Big Clamp on) – 3 turns through center
Ports 7 to 15 : - FSB31-1/2 – multiple turns through choke – ½” diameter hole
Total ferrites: - F240 rings (1), FSB31-1 (4), FSB31-1/2 (10)
Also make sure you connect a good RF ground to the amplifier ground post.
KPA1500
This RFI Kit Includes are the following filters and installation guidelines:
RF Input:F240 ring – 5-9 turns of RG-58/8X size through center
RF Output:# 1 - FSB31-1 (Big Clamp on) – 3 turns of RG-8 size cable
RF Output:# 2 - FSB31-1 (Big Clamp on) – 3 turns of RG-8 size cable
PA KEY Cable: - FSB31-1/2 – multiple turns through choke – ½” diameter hole
DC Power Line: - FSB31-1 (Big Clamp on) – 2 turns through center
AC Line of DC Power Supply: - FSB31-1 (Big Clamp on) – 3 turns through center
Ports 7 to 15 : - FSB31-1/2 – multiple turns through choke – ½” diameter hole
Total ferrites: - F240 rings (1), FSB31-1 (4), FSB31-1/2 (10)
Also make sure you connect a good RF ground to the amplifier ground post.
