5:1 CUBE™ Unun – Model CU-5-1500 (50:250 Ohm, 1.8-61 MHz, 1.5KW PEP)
Application. For traveling wave, end fed or portable 20-31 foot vertical antennas the 5:1 unun makes a good transformer for converting 50 ohm coax to a 250 ohm feed point. If you use the antenna on multiple bands, the feed point impedance may not always be 250 ohms and use of the unun at high (>350 ohms) or low (<100 ohms) will require reduced power input or the unun may have its power ratings exceeded and damage to the unun may occur. The (5:1 conversion ratio will change for loads other than 250 ohms unbalanced.
Typical application:
Also available as a balanced output – CB-5-1500
Automotive Battery Charger RFI Kit - - 1-300 MHz RFI SuppressionProduct DetailsThis kit suppresses EMI and RFI generated from DC battery charger such as used on automotive batteries uo to 100 amps output.
Simple snap on the ferrite suppressors (1" hole size) onto the AC input using multiple turns through the center and do the same for the DC output cables. The more turns through the center the hiogher the RFI suppression.
Simple - Effective and Low Cost solution.to suppress charger noise fed back into AC power lines acting as RFI transmitting antennas!
This kit suppresses EMI and RFI generated from DC battery charger such as used on automotive batteries uo to 100 amps output.
Simple snap on the ferrite suppressors (1" hole size) onto the AC input using multiple turns through the center and do the same for the DC output cables. The more turns through the center the hiogher the RFI suppression.
Simple - Effective and Low Cost solution.to suppress charger noise fed back into AC power lines acting as RFI transmitting antennas!