5:1 CUBE™ Unun – Model CU-5-1500 (50:250 Ohm, 1.8-61 MHz, 1.5KW PEP)
Application. For traveling wave, end fed or portable 20-31 foot vertical antennas the 5:1 unun makes a good transformer for converting 50 ohm coax to a 250 ohm feed point. If you use the antenna on multiple bands, the feed point impedance may not always be 250 ohms and use of the unun at high (>350 ohms) or low (<100 ohms) will require reduced power input or the unun may have its power ratings exceeded and damage to the unun may occur. The (5:1 conversion ratio will change for loads other than 250 ohms unbalanced.
Typical application:
Also available as a balanced output – CB-5-1500
50:450 ohm (9:1) Balun or Unun Core Kit, .5-32 MHz, 1000 watts PEP, end fed/Ladder Line, T2FD antennaProduct DetailsMPN: BA-9-1000Type: balun or ununInput ohms/Output ohms: 50 in, 450 outFrequency Range < 2:1 SWR (MHz): .5-32PEP Power Rating (watts): 1000 Watts PEPAntenna Compatability: Unun: End fed, Balun: Ladder linePurpose. Model BA-9-1000 is a 9:1 balun/unun kit (assembly required from parts supplied) used to translate a 50 ohm input up to 450 ohms at RF power levels up to 1000 watts when used with a matched load. It provides conversion from unbalanced coax to balanced ladder line/antenna feed point and gives a 9:1 impedance step-up to reduce SWR on the coax. Place at the junction of the balanced line and the coax to convert from balanced line to unbalanced coax.It can also be wired as an UNUN with unbalanced coax input to unbalanced output such as an end fed antenna.
KIT Contents. The kit consists of a F240-61 ferrite toroidal core, three colors of insulated wire, a SO-239 UHF connector with stainless steel hardware, and an instruction manual.
Assembly time: About 1 hour
Radio Club idea:
Buy 10 for a club do it yourself construction project - you can learn something and also build an end fed antenna (just add wire).
Purpose. Model BA-9-1000 is a 9:1 balun/unun kit (assembly required from parts supplied) used to translate a 50 ohm input up to 450 ohms at RF power levels up to 1000 watts when used with a matched load. It provides conversion from unbalanced coax to balanced ladder line/antenna feed point and gives a 9:1 impedance step-up to reduce SWR on the coax. Place at the junction of the balanced line and the coax to convert from balanced line to unbalanced coax.It can also be wired as an UNUN with unbalanced coax input to unbalanced output such as an end fed antenna.
KIT Contents. The kit consists of a F240-61 ferrite toroidal core, three colors of insulated wire, a SO-239 UHF connector with stainless steel hardware, and an instruction manual.
Assembly time: About 1 hour
Radio Club idea:
Buy 10 for a club do it yourself construction project - you can learn something and also build an end fed antenna (just add wire).
