The ZS6BKW antenna is a better match for our bands than the G5RV. The method of construction and tuning is essentially the same for both antennas but the dimensions are different.
Here is the ZS6BKW antenna installed at AK6R fine tuned for the CW/FT8 frequencies on 40-20-17-12-10 meters. An excellent antenna when installed at 30 feet or higher and no tuner required avoiding the tuner losses and constant retuning. If you want to work all bands from 80-10 install an antenna tuner between the 1:1 balun and the amplifier and ignore the 39/40 switch.
Is this the best FT8 antenna? – I think so as I has made over 70,000 contacts and it still is a proven winner -Good world wide DX, easy to install, no tuner and takes full legal limit.
Here are several different 1:1 baluns you can use depending on power requirements:
This RFI kit was created to suppress RFI issues with your cable tv box interference. This kit was created out of necessity from a ham using high power antennas near the cable TV box. The use of the ferrite filters completely eliminated the RFI issue allowing the ham to enjoy the use of the cable TV system while using the ham radio system.
The ferrite filters are selected to suppress RFI from 1 to 300 MHz. The filters are easy to install, don’t require modification of the protected equipment and work in almost all cases. See product picture for suggested filter use.
What is included in the kit?
The RFI-CABLETV kit contains a snap on filter for the AC power cord, the HDMI/Video output cable and the and coax cable TV input cable.
You get three 1/2" ID snap on RFI filters and an installation manual.
You need 1 RFI-CABLETV RFI kit for each cable TV box afflicted with RFI.
For additional protection of the video monitor use the RFI-HDTV RFI kit which suppresses RFI coming into the AC power line into the HDTV.
Here is the Coax Noise Filter used to suppress coax common mode currents (works for all type of antennas)
PDF of ZS6BKW at AK6R Construction Article HERE: My ZS6BKW Antenna