G5RV/ZS6BKW Antennas

The ZS6BKW antenna is a better match for our bands than the G5RV. The method of construction and tuning  is essentially the same for both antennas but the dimensions are different.

Here is the ZS6BKW antenna installed at AK6R fine tuned for the CW/FT8 frequencies on 40-20-17-12-10 meters.  An excellent antenna when installed at 30 feet or higher and no tuner required avoiding the tuner losses and constant retuning.  If you want to work all bands from 80-10 install an antenna tuner between the 1:1 balun and the amplifier and ignore the 39/40 switch.

Is this the best FT8 antenna?  – I think so as I has made over 70,000 contacts and it still is a proven winner -Good world wide DX, easy to install, no tuner and takes full legal limit.

PAL ZS68006 Ant Layout - G5RV/ZS6BKW Antennas

 

Here are several different 1:1 baluns you can use depending on power requirements:

Heil Parametric Receive Audio System RFI Kit - 6 filters

SKU RFI-PRAS
$49.95
NEW
Bulk pricing available for quantities of 2 units or more
1
Buy more, save more
QuantityPrice per itemDiscount
2 items$44.9510% off
Save this product for later
Customer reviews
No reviews yet. Only signed-in customers who bought this product can leave reviews. To leave a review, sign in
Share this product with your friends
Heil Parametric Receive Audio System RFI Kit - 6 filters
Product Details
MPN: RFI-PRAS
Type: NEW
Country/Region of Manufacture: USA
Filter Power Rating (PEP watts): not applicable
RFI Suppression Range (MHz): 1-300 MHz

This RFi kit was created to eliminate RFI issues from the excellent Heil Parametric Receive Audio System which can highly tailor audio signal from your radio to a a powered speaker or multiple headphones. However when installed near a high powered HF antenna it can ave RFi issues. This kit was created out of necessity from a ham using high power antennas near the radio. The use of the ferrite filters completely eliminated the RFI issue allowing the ham to enjoy the use of the PRAS.

The ferrite filters are selected to suppress RFI from 1 to 300 MHz. The filters are easy to install, don’t require modification of the protected equipment and work in almost all cases. See product picture for suggested filter use.

What is included in the kit?

The RFI-PRAS kit contains a a ring filter for the AC power cord used on the DC supply cables to the PRAS and high powered speakerr and 3 additional snap-on filters for the both ends of the speaker cable and for the audio input (from the transceiver/audio source) to the PRAS..

You get 1 ring filter and 5 1/2" ID snap on filters and an installation manual.


 

Here is the Coax Noise Filter used to suppress coax common mode currents (works for all type of antennas)

 

PDF of ZS6BKW at AK6R Construction Article HERE: My ZS6BKW Antenna