The ZS6BKW antenna is a better match for our bands than the G5RV. The method of construction and tuning is essentially the same for both antennas but the dimensions are different.
Here is the ZS6BKW antenna installed at AK6R fine tuned for the CW/FT8 frequencies on 40-20-17-12-10 meters. An excellent antenna when installed at 30 feet or higher and no tuner required avoiding the tuner losses and constant retuning. If you want to work all bands from 80-10 install an antenna tuner between the 1:1 balun and the amplifier and ignore the 39/40 switch.
Is this the best FT8 antenna? – I think so as I has made over 70,000 contacts and it still is a proven winner -Good world wide DX, easy to install, no tuner and takes full legal limit.
Here are several different 1:1 baluns you can use depending on power requirements:
Mix 31 Ferrite Snap On Combo pack (RFI Suppression range is 1-300 MHz)
The Ferrite Snap On Combo Pack is a convenient solution for troubleshooting RFI/EMI with various diameter cables ranging from 1/4″ to 3/4″ for use as either single turn or multiple turn ferrite chokes.
The snap on chokes are useful for RF coax, AC/DC power cables, and device interconnection cables.
Always use a snap on ferrite with a larger inside diameter than the diameter of the cable and use multiple turns if possible (2 turns through the snap on is the same as 4 snap ons with 1 turns in series).
Included in the combo pack are our most popular snap on sizes as follows:
FSB31-1/4 – 1/4″ ID – 6 pieces
FSB31-3/8 – 3/8″ ID – 6 pieces
FSB31-1/2 – 1/2″ ID – 6 pieces
FSB31-3/4 – 3/4″ ID – 4 pieces
Here is the Coax Noise Filter used to suppress coax common mode currents (works for all type of antennas)
PDF of ZS6BKW at AK6R Construction Article HERE: My ZS6BKW Antenna