G5RV/ZS6BKW Antennas

The ZS6BKW antenna is a better match for our bands than the G5RV. The method of construction and tuning  is essentially the same for both antennas but the dimensions are different.

Here is the ZS6BKW antenna installed at AK6R fine tuned for the CW/FT8 frequencies on 40-20-17-12-10 meters.  An excellent antenna when installed at 30 feet or higher and no tuner required avoiding the tuner losses and constant retuning.  If you want to work all bands from 80-10 install an antenna tuner between the 1:1 balun and the amplifier and ignore the 39/40 switch.

Is this the best FT8 antenna?  – I think so as I has made over 70,000 contacts and it still is a proven winner -Good world wide DX, easy to install, no tuner and takes full legal limit.

PAL ZS68006 Ant Layout - G5RV/ZS6BKW Antennas

 

Here are several different 1:1 baluns you can use depending on power requirements:

DSL/Cable Modem/Router/Ethernet/Internet RFI Kit - 3 Filters

SKU RFI-ROUTER-4
$19.95
# Ethernet Ports
1
Save this product for later
Share this product with your friends
DSL/Cable Modem/Router/Ethernet/Internet RFI Kit - 3 Filters
Product Details
MPN: RFI-ROUTER
Type: New
Country/Region of Manufacture: United States
Filter Power Rating (PEP watts): n/a
RFI Suppression Range (MHz): 1-300 MHz
# Ferrite Filters: 3 or 5 depending on model
Enclosure Size (inches): n/a
Typical Use:: 1-2 turns on all I/O cables

Use for DSL/cable modems, routers, access points, repeaters, Ethernet switches, etc.

The RFI-ROUTER-4 kit is meant to be used with a DSL Modem/Router with incoming DSL signal, up to 4 Ethernet lines and a single power DC power supply line coming into the device.Included are one snap on ferrite (3/4” hole) and two (3/4” hole) snap on split ferrite beads for the Ethernet outputs (2 per snap on using multiple turns for each cable). The additional 3/4" snap on is for the power supply line. The RFI-ROUTER-8 kit is identical but has 2 additional ferrite snap on for up to 4 additional ports,

Useful for all brands of computer equipment.

 

Here is the Coax Noise Filter used to suppress coax common mode currents (works for all type of antennas)

 

PDF of ZS6BKW at AK6R Construction Article HERE: My ZS6BKW Antenna