G5RV/ZS6BKW Antennas

The ZS6BKW antenna is a better match for our bands than the G5RV. The method of construction and tuning  is essentially the same for both antennas but the dimensions are different.

Here is the ZS6BKW antenna installed at AK6R fine tuned for the CW/FT8 frequencies on 40-20-17-12-10 meters.  An excellent antenna when installed at 30 feet or higher and no tuner required avoiding the tuner losses and constant retuning.  If you want to work all bands from 80-10 install an antenna tuner between the 1:1 balun and the amplifier and ignore the 39/40 switch.

Is this the best FT8 antenna?  – I think so as I has made over 70,000 contacts and it still is a proven winner -Good world wide DX, easy to install, no tuner and takes full legal limit.

PAL ZS68006 Ant Layout - G5RV/ZS6BKW Antennas

 

Here are several different 1:1 baluns you can use depending on power requirements:

ACOM 2000 HF Linear Amplifier + Remote Control Unit RFI Kit - 8 RFI/Noise Reduction Filters

SKU RFI-LA-AC2000
$79.95
Bulk pricing available for quantities of 2 units or more
1
Buy more, save more
QuantityPrice per itemDiscount
2 items$74.956% off
10 items$69.9513% off
Save this product for later
Share this product with your friends
ACOM 2000 HF Linear Amplifier + Remote Control Unit RFI Kit - 8 RFI/Noise Reduction Filters
Product Details
MPN: RFI-LA-AC2000
Filter Power Rating (PEP watts): coax cable limit
RFI Suppression Range (MHz): 1-60 MHz
# Ferrite Filters: 8

PURPOSE

These kits are designed to choke common mode currents going into or exiting from your amplifier cables.Filters are supplied for the RF In, RF Out, Relay Cable/control lines, remote control unit and AC power line.Use of the filters often helps cure SWR problems between amp exciter and amp and between amp and antenna tuner or direct to antenna.The AC power line choke helps keep common mode current out of the power line which could cause interference to other devices connected to the same power line if not suppressed.

USE

KIT INCLUDES

Filter Type

Usage

Ferrites

F240 Ring (1.4” ID)

Transceiver RF coaxr

1

Snap On (1/2” ID)

Remote Control Unit cables

5

Snap On (1” ID)

RF Output, AC/DC power

2

Total Filters


8

INSTALLATION GUIDELINES

Amp RF Input:Ring Filter (1.4” ID) – 5-9 turns of RG-58/8X size through center

Amp RF Output:Snap On Filter (1” ID) – 3 turns of coax cable through center

RCU Cables:Snap On Filter (1/2” ID) – multiple turns through center

AC Power:Snap On Filter (1” ID) – 3 turns of power cord through center


 

Here is the Coax Noise Filter used to suppress coax common mode currents (works for all type of antennas)

 

PDF of ZS6BKW at AK6R Construction Article HERE: My ZS6BKW Antenna