The ZS6BKW antenna is a better match for our bands than the G5RV. The method of construction and tuning is essentially the same for both antennas but the dimensions are different.
Here is the ZS6BKW antenna installed at AK6R fine tuned for the CW/FT8 frequencies on 40-20-17-12-10 meters. An excellent antenna when installed at 30 feet or higher and no tuner required avoiding the tuner losses and constant retuning. If you want to work all bands from 80-10 install an antenna tuner between the 1:1 balun and the amplifier and ignore the 39/40 switch.
Is this the best FT8 antenna? – I think so as I has made over 70,000 contacts and it still is a proven winner -Good world wide DX, easy to install, no tuner and takes full legal limit.
Here are several different 1:1 baluns you can use depending on power requirements:
Model CU-9-5000 is a 9:1 multi-core unun housed in a NEMA enclosure box (4″ x 4″ x 2″) with top stud/eyebolt output used to translate a 50 ohm input up to 450 ohms at RF power levels up to 5000 watts PEP (SSB) when used with a matched load. Usable to 61 MHz under 2:1 SWR with matched load.
Great for end fed antennas - FT-8 and digital mode power ratings are approximately 30% of PEP ratings into a matched 450 ohm load. For non-resonant end fed antennas, you will need a feed line choke on the coax. See typical antenna configuration notes below for details.
Non-Resonant End Fed Antenna Configuration Notes
Here is the Coax Noise Filter used to suppress coax common mode currents (works for all type of antennas)
PDF of ZS6BKW at AK6R Construction Article HERE: My ZS6BKW Antenna