G5RV/ZS6BKW Antennas

The ZS6BKW antenna is a better match for our bands than the G5RV. The method of construction and tuning  is essentially the same for both antennas but the dimensions are different.

Here is the ZS6BKW antenna installed at AK6R fine tuned for the CW/FT8 frequencies on 40-20-17-12-10 meters.  An excellent antenna when installed at 30 feet or higher and no tuner required avoiding the tuner losses and constant retuning.  If you want to work all bands from 80-10 install an antenna tuner between the 1:1 balun and the amplifier and ignore the 39/40 switch.

Is this the best FT8 antenna?  – I think so as I has made over 70,000 contacts and it still is a proven winner -Good world wide DX, easy to install, no tuner and takes full legal limit.

PAL ZS68006 Ant Layout - G5RV/ZS6BKW Antennas

 

Here are several different 1:1 baluns you can use depending on power requirements:

50:200 ohm (4:1) Dual Core Current Balun Kit, 1-55 MHz, 1500 watts PEP, for OCF, Loop, Ladder Line Antennas

Ladderline to Coax Transformer
SKU BA-4-1500DC
$37.95
Bulk pricing available for quantities of 2 units or more
1
Buy more, save more
QuantityPrice per itemDiscount
2 items$34.958% off
10 items$31.9516% off
Save this product for later
Share this product with your friends
50:200 ohm (4:1) Dual Core Current Balun Kit, 1-55 MHz, 1500 watts PEP, for OCF, Loop, Ladder Line Antennas
Product Details
MPN: BA-4-1000DC
Type: balun or unun
Input ohms/Output ohms: 50 in, 200 out
Frequency Range < 2:1 SWR (MHz): 1-55
PEP Power Rating (watts): 1500 Watts PEP
Antenna Compatability: Balun: Ladder line to coax interface

Purpose. Model BA-4-1500DC is a 4:1 dual core balun kit (assembly required from parts supplied) used to translate a 50 ohm input up to 200 ohms at RF power levels up to 1000 watts when used with a matched load. It provides conversion from unbalanced coax to balanced ladder line/antenna feed point and gives a 4:1 impedance step-up to reduce SWR on the coax. Place at the junction of the balanced line and the coax to convert from balanced line to unbalanced coax.

KIT Contents. The kit consists of a 2 ferrite toroidal cores, two colors of insulated wire, a SO-239 UHF connector with stainless steel hardware, and an instruction manual.

Assembly time: About 1 hour, illustrated manual included with purchase.

Radio Club idea:

Buy 10 for a club do it yourself construction project - you can learn something and also build an end fed antenna (just add wire).

Product picture shows assembled item of all components in kit.

NOTE: for higher power and a true current balanced 4:1, use our BA-4-1500DC dual core 4;1 balun kit


 

Here is the Coax Noise Filter used to suppress coax common mode currents (works for all type of antennas)

 

PDF of ZS6BKW at AK6R Construction Article HERE: My ZS6BKW Antenna