The Ferrite Snap On Combo Pack is a convenient solution for troubleshooting RFI/EMI with various diameter cables ranging from 1/4″ to 3/4″ for use as either single turn or multiple turn ferrite chokes. The snap on chokes are useful for RF coax, AC/DC power cables, and device interconnection cables.
Always use a snap on with a larger inside diameter than the diameter of the cable and use multiple turns if possible (2 turns through the snap on is the same as 4 snap ons with 1 turns). Included in these combo packs are our most popular snap on sizes as follows:
1500 Watt Rated 1:1 CUBE™ Unun
Th CU-1-1500 unun is useful as common mode feed line chokes or coax to antenna interfaces. SO-239 output models can also be used with balanced antennas if a short coax cable “pigtail” is used on the output and connected to the antenna. Rated 1500 Watts PEP from 1.8-61 MHz.
Use as line isolator, antenna interface, or as a common mode choke to keep RF on the antenna and off the outside of the coax braid.
Much more effective then our sleeve feed line chokes due to our exclusive Multimix(TM) multi-core topology using high permeability ferrite cores which provides a high choking impedance over a broad frequency range.
Typical common mode suppression is 20-38 dB (up to 6 "S" units) from 1.8-61 MHz reduces common mode current! For most effective results, use 1 choke at the antenna and another at the radio. Helps reduce noise floor too by choking off common mode neighborhood noise picked up on outside of coax braid.
Optionally available with both input and output on same side for certain installations and wall mounts available on each side for both models.
Choose SO-239 UHF or N connector input/output connectors