The Ferrite Snap On Combo Pack is a convenient solution for troubleshooting RFI/EMI with various diameter cables ranging from 1/4″ to 3/4″ for use as either single turn or multiple turn ferrite chokes. The snap on chokes are useful for RF coax, AC/DC power cables, and device interconnection cables.
Always use a snap on with a larger inside diameter than the diameter of the cable and use multiple turns if possible (2 turns through the snap on is the same as 4 snap ons with 1 turns). Included in these combo packs are our most popular snap on sizes as follows:
1500 Watt PEP Rated 1:1 CUBE™ Balun for dipoles
* Help keep RF out of the shack.
* Provides maximum transfer of RF to the antenna.
* Suppress radiation from the feeder cable
* Makes the antenna radiation pattern predictable.
* Outperforms the competition by 24 dB common mode rejection! (see graphs)
* Reduces QRN and TVI to the neighbors.
The CB-1-1500 balun is useful as common mode feed line chokes or unbalanced coax to balanced antenna interface. SO-239 input to side terminal/eyebolt output. . Rated 1500 Watts PEP from 1-61 MHz. Common mode rejection up to -38dB over the frequency range. The CB-1-1500 is the balun version and the CU-1-1500 is the unun version (coax in and coax out).
Use as line isolator, antenna interface, or as a common mode choke to keep RF on the antenna and off the outside of the coax braid. Much more effective then our snap on ferrite beads as this balun which provides a higher choking impedance over a broad frequency range.
For most effective results, use another feed line choke (coax noise filter) at the radio. Helps reduce noise floor too by choking off common mode neighborhood noise picked up on outside of coax braid acting as secondary receive antenna
