The Ferrite Ring Combo Pack is a convenient solution for troubleshooting RFI/EMI from unknown frequencies or multiple frequencies that require multiple suppression mixes. Included in this combo pack are ten 2.4″ OD/1.4″ ID ring toroids as follows:
Mix 75 effective from .15-10 MHz including AM Broadcast band – quantity: 3
Mix 31 effective from 1-300 MHz for general purpose – quantity: 4
Mix 61 effective from 200-2000 MHz for cell phone, WIFI, HDTV, Cable TV interference – quantity: 3
PURPOSE
These kits are designed to choke common mode currents going into or exiting from your amplifier cables.Filters are supplied for the RF In, RF Out, Relay Cable/control lines, and AC power line.Use of the filters often helps cure SWR problems between amp exciter and amp and between amp and antenna tuner or direct to antenna.The AC power line choke helps keep common mode current out of the power line which could cause interference to other devices connected to the same power line if not suppressed.
USE
Standard kit for amplifiers with single input, single output, relay keying and AC input
Deluxe Kit for amplifiers with dual inputs/outputs, frequency/keying control lines
KIT INCLUDES
|
Filter Type |
Usage |
Standard Kit |
Deluxe kit |
|
F240 Ring (1.4” ID) |
RF Exciter input |
1 |
2 |
|
Snap On (1/2” ID) |
Ethernet, PTT control |
2 |
2 |
|
Snap On (1” ID) |
RF Output |
1 |
2 |
|
Snap On (1” ID) |
120/240 VAC Input |
1 |
1 |
|
Total Filters |
5 |
7 |
INSTALLATION GUIDELINES
Standard Kit - Part# RFI-LA-FLEX-1
RF Input:Ring Filter (1.4” ID) – 5-9 turns of RG-58/8X size through center
RF Output:Snap On Filter (1” ID) – 3 turns of coax cable through center
PTT Relay Cable:Snap On Filter (1/2” ID) – multiple turns through center
Ethernet Cable:Snap On Filter (1/2” ID) – multiple turns through center
AC Power:Snap On Filter (1” ID) – 3 turns of power cord through center
Deluxe Kit - Part# RFI-LA-FLEX-2
RF Input (2)Ring Filter (1.4” ID) – 5-9 turns of RG-58/8X size through center
RF Output: (2)Snap On Filter (1” ID) – 3 turns of coax cable through center
PTT Relay Cable:Snap On Filter (1/2” ID) – multiple turns through center
Ethernet Cable:Snap On Filter (1/2” ID) – multiple turns through center
AC Power:Snap On Filter (1” ID) – 3 turns of power cord through center
Also make sure you connect a good RF ground to the amplifier ground post.
The ring toroids are useful for AC/DC common mode choking with multiple turns as shown below
 AC Cable on F-240 Toroid – 7 turns |
 DC Cable on F240 – 4 turns |
The ring toroids can also be used on coax or signal lines as shown below:
 RG58 12 turns on FT240 |
 Ethernet Cable on F-240 Toroid – 7 turns |
For RFI/EMI wrap as many turns as possible for higher choking (under 30 mHz).