The Ferrite Ring Combo Pack is a convenient solution for troubleshooting RFI/EMI from unknown frequencies or multiple frequencies that require multiple suppression mixes. Included in this combo pack are ten 2.4″ OD/1.4″ ID ring toroids as follows:
Mix 75 effective from .15-10 MHz including AM Broadcast band – quantity: 3
Mix 31 effective from 1-300 MHz for general purpose – quantity: 4
Mix 61 effective from 200-2000 MHz for cell phone, WIFI, HDTV, Cable TV interference – quantity: 3
The Bullet-2-1-500EB (500 watts PEP) or the SBULLET-2-1-1500EB (1500 watts PEP) are both multi-core, 2:1 (50 ohm to 100 ohm) baluns plus a 1:1 feed line choke in a single compact (looks like a bullet) enclosure that is lightweight and easy to transport for your fixed/portable.
Very useful for single band horizontal or vertical loop antenna systems. Halyard hoist at top of balun for convenient attachment point. Input is via SO-239 UHF coax connector and output with side eye bolt output.
For multi-band loop antennas consider the Bullet-4-1-500EB or SBULLET-4-1-1500EB
Remember we over engineer our products, to out perform our competition - just compare the weight and frequency range of our baluns to theirs and you will know we put much more into our products so you don't have to worry about failure at a critical moment.
The ring toroids are useful for AC/DC common mode choking with multiple turns as shown below
 AC Cable on F-240 Toroid – 7 turns |
 DC Cable on F240 – 4 turns |
The ring toroids can also be used on coax or signal lines as shown below:
 RG58 12 turns on FT240 |
 Ethernet Cable on F-240 Toroid – 7 turns |
For RFI/EMI wrap as many turns as possible for higher choking (under 30 mHz).