The Ferrite Ring Combo Pack is a convenient solution for troubleshooting RFI/EMI from unknown frequencies or multiple frequencies that require multiple suppression mixes. Included in this combo pack are ten 2.4″ OD/1.4″ ID ring toroids as follows:
Mix 75 effective from .15-10 MHz including AM Broadcast band – quantity: 3
Mix 31 effective from 1-300 MHz for general purpose – quantity: 4
Mix 61 effective from 200-2000 MHz for cell phone, WIFI, HDTV, Cable TV interference – quantity: 3
Model BA-9-250 is a 9:1 balun/unun kit (assembly from parts supplied required) used to translate a 50 ohm input up to 450 ohms at RF power levels up to 250 watts PEP when used with a matched load. With a matched 450 ohm load the SWR over the frequency range 1.8 to 30 MHz is shown in the following table measured with an AIM 4170 network analyzer. Notice that the conversion from 450 to 50 ohms is very consistent from 1-31 MHz and SWR is less than 2:1 over most of the range allowing easy tuning by most radio internal antenna tuners or an external tuner. Graph is for a 9:1 unun often used with long wire or end fed antennas.
Radio Club idea:
Typical SWR curve for this project:
The ring toroids are useful for AC/DC common mode choking with multiple turns as shown below
 AC Cable on F-240 Toroid – 7 turns |
 DC Cable on F240 – 4 turns |
The ring toroids can also be used on coax or signal lines as shown below:
 RG58 12 turns on FT240 |
 Ethernet Cable on F-240 Toroid – 7 turns |
For RFI/EMI wrap as many turns as possible for higher choking (under 30 mHz).