The Ferrite Ring Combo Pack is a convenient solution for troubleshooting RFI/EMI from unknown frequencies or multiple frequencies that require multiple suppression mixes. Included in this combo pack are ten 2.4″ OD/1.4″ ID ring toroids as follows:
Mix 75 effective from .15-10 MHz including AM Broadcast band – quantity: 3
Mix 31 effective from 1-300 MHz for general purpose – quantity: 4
Mix 61 effective from 200-2000 MHz for cell phone, WIFI, HDTV, Cable TV interference – quantity: 3
Purpose. Model BA-4-1500DC is a 4:1 dual core balun kit (assembly required from parts supplied) used to translate a 50 ohm input up to 200 ohms at RF power levels up to 1000 watts when used with a matched load. It provides conversion from unbalanced coax to balanced ladder line/antenna feed point and gives a 4:1 impedance step-up to reduce SWR on the coax. Place at the junction of the balanced line and the coax to convert from balanced line to unbalanced coax.
KIT Contents. The kit consists of a 2 ferrite toroidal cores, two colors of insulated wire, a SO-239 UHF connector with stainless steel hardware, and an instruction manual.
Assembly time: About 1 hour, illustrated manual included with purchase.
Radio Club idea:
Buy 10 for a club do it yourself construction project - you can learn something and also build an end fed antenna (just add wire).
Product picture shows assembled item of all components in kit.
NOTE: for higher power and a true current balanced 4:1, use our BA-4-1500DC dual core 4;1 balun kit
The ring toroids are useful for AC/DC common mode choking with multiple turns as shown below
 AC Cable on F-240 Toroid – 7 turns |
 DC Cable on F240 – 4 turns |
The ring toroids can also be used on coax or signal lines as shown below:
 RG58 12 turns on FT240 |
 Ethernet Cable on F-240 Toroid – 7 turns |
For RFI/EMI wrap as many turns as possible for higher choking (under 30 mHz).