PURPOSE

These kits are designed to choke common mode currents going into or exiting from your Tuner Genius cables. Filters are supplied for the RF Input (s) RF Outputs, DC power and LAN input. The DC power line choke helps keep common mode current out of the power line which could cause interference to other devices connected to the same power line if not suppressed. The LAN cable choke keeps any RFI off the LAN cable input.

USE

RFI-AT-FLEX-TG Standard kit for tuners with SO2R option and RFI-AT-FLEX-TG3 for tuners with 3 antenna outputs option (1X3).

Note if you use other cables into the tuner such as PTT or otherwise, use FSB31-1/2 snap on ferrites for these lines and wind 2 or more turns thru center if possible. These ferrites sold separately.

KIT INCLUDES

INSTALLATION GUIDELINES

SO2R Kit - Part# RFI-AT-FLEX-TG (2 Inputs, 2 Outputs)

RF Output:Snap On Filter (1” ID) – 3 turns (1/2" cable) or 6 turns (1/4" cable) of coax cable through center for each output - Use 1 for channel A and one for channel B Output

RF Input Snap On (1" ID) - 3 turns (1/2" cable) or 6 turns (1/4" cable) of coax cable through center for each input - Use one for channel A and one for channel B Input

Ethernet Cable:Snap On Filter (1/2” ID) – multiple turns through center

DC Power:Snap On Filter (1/2” ID) – 2 or more turns of DC (+ and -) power cord through center

3 Antenna Kit - Part# RFI-AT-FLEX-TG3 (3 Antennas, 1 input)

RF Output:Snap On Filter (1” ID) – 3 turns (1/2" cable) or 6 turns (1/4" cable) of coax cable through center for each output

RF Input Snap On (1" ID) - 3 turns (1/2" cable) or 6 turns (1/4" cable) of coax cable through center for TX input

Ethernet Cable:Snap On Filter (1/2” ID) – multiple turns through center

DC Power:Snap On Filter (1/2” ID) – 2 or more turns of DC (+ and -) power cord through center

Also make sure you connect a good RF ground to the tuner ground post.