HF Impedance Transformer Kits

Does the operation of a treadmill or your exercise equipment wipe out your radio receiver reception? We have heard cases where the treadmill from a neighbor’s house wiped out the ham radio receiver reception from 2-30 Mhz! The treadmill source was finally isolated to a variable speed motor power supply that was injecting RFI into the AC wiring of the house and the AC wiring was acting as a transmitting antenna broadcasting the signal to the entire neighborhood. The case was difficult to track down since the broadband RFI interference only occurred at 7-8 pm each nite when the neighbor used the treadmill. As with all RFI cases the sequence is similar: Find the Source, Choke the Path, Protect the Victim.

Once the source was identified, a simple solution was to choke off the transmitting antenna with a AC line choke shown below which eliminated the interference problem to the ham receiver:

Testimonials

F400-31 AC Power Cord Choke completely cured the RFI problem I had with my wife’s treadmill. Now I can hear the weak signals!

73,
Jim K4AXF
Icom IC-725
Grottoes, Shenandoah Valley, Virginia
Refine by
 

Filters

Filters
These impedance transformer kits have been designed for the Do-It-Yourself (DIY) enthusiast and Instructor workshops on baluns and ununs for antenna matching and RFI use.

The impedance transformers are classified in ratios of 2:1 (100:50 ohm) to 16:1 (800:50 ohm).  The outputs can be configured as balanced (Balun) or as unbalanced (unun) with respect to the inputs which are considered all unbalanced coax at 50 ohms.  All impedance transformers are designed for 1.8-31 MHz unless otherwise specified.