HF Impedance Transformer Kits

2465476302 - HF Impedance Transformer Kits
+3

Elecraft KPA500 HF Linear Amplifier RFI Kit - 5 Filters for RF In/Out, AC Power, PA KEY, Computer Control/AUX/RS232

RFI-ELECRAFT-KPA500
$49.95
In stock
1
Product Details
MPN: RFI-ELECRAFT-KPA500
Type: New
Country/Region of Manufacture: United States
Filter Power Rating (PEP watts): coax cable limit
RFI Suppression Range (MHz): 1-300 MHz
# Ferrite Filters: 5
Typical Use:: AC power, RF In/out, I/O control cables

This is a generic linear amplifier RFI kit for DC powered amplifiers. Works on many popular amplifiers including:

Specially designed for the Elecraft KPA500 linear amplifier used with the KX3 and similar transceivers.

Included are the following chokes and installation guidelines:

Included are the following chokes and installation guidelines:

RF Input:F240 ring – 5-9 turns of RG-58 size through center

RF Output:FSB-1 (Big Clamp on) – 3 turns of RG-8 size cable

PA KEY Cable:FSB-1/2 – multiple turns through choke – ½” diameter hole

AC Power Line:F240 ring – 5-6 turns through center

Computer/RS232/AUX Cable:FSB-1/2 – multiple turns through choke – ½” diameter hole

Also make sure you connect a good RF ground to the amplifier ground post.

Save this product for later
Display prices in: USD
These impedance transformer kits have been designed for the Do-It-Yourself (DIY) enthusiast and Instructor workshops on baluns and ununs for antenna matching and RFI use.

The impedance transformers are classified in ratios of 2:1 (100:50 ohm) to 16:1 (800:50 ohm).  The outputs can be configured as balanced (Balun) or as unbalanced (unun) with respect to the inputs which are considered all unbalanced coax at 50 ohms.  All impedance transformers are designed for 1.8-31 MHz unless otherwise specified.