1″/25.4mm max Cable Size Chokes
Model BA-200. For use with RG-218 and similar size cables up to 1" OD without connectors installed. Works on all impedance cables, 1.8-300 MHz. Choke outside diameter is 2 inches Requires 9-1/2 inches of cable for 5 bead version, 17" of cable for 10 bead version, and 25" of cable for 15 bead version. Use BA-200-10 or BA-200S-15 for higher choking below 21 MHz. For 10-12 meter frequency use 5 beads up to 15 KW PEP, 10 beads for up to 30 KW PEP and 15 beads for up to 45 KW PEP. We use mix 31 for all chokes. Heat shrink weather proofing kit included. Picture shows 10 bead version.
Rule of thumb suggests you need minimum 5x-10x the coax line impedance for effective choking and the more the better as it will reduce common mode current with higher choking impedance. Select chokes with minimum of 500 ohms at your frequency of interest for best results or upgrade to our CUBE(TM), TUBE(TM), Super Choker(TM) chokes up to 15,000 ohms choking.
Select 10 bead version for 160 meter use, 15 bead version for even higher choking power on lower frequencies. Power rating is same as coax cable used power rating.
Typical choking impedances (BA-58, BA-8, BA-200):
16:1 Ununs are useful between coax and long wires with a load impedance near 800 ohms like a beverage antenna. Shortwave listener antennas also can benefit with the 16:1 unun and it may provide a better match than 9:1 ununs – this means quieter noise levels and stronger signals so you can hear distance stations easier.