12:1 Baluns/Ununs

FLEX PGXL Linear Amplifier RFI Kit - Single/Dual I/O Options

SKU RFI-LA-FLEX-1
$59.95
Input/Ouput RF Ports
1
Save this product for later
Customer reviews
No reviews yet. Only signed-in customers who bought this product can leave reviews. To leave a review, sign in
Share this product with your friends
FLEX PGXL Linear Amplifier RFI Kit - Single/Dual I/O Options
Product Details
MPN: RFI-LA-FLEX-1 or RFI-LA-FLEX-2
RFI Suppression Range (MHz): 1-100 MHz

PURPOSE

These kits are designed to choke common mode currents going into or exiting from your amplifier cables.Filters are supplied for the RF In, RF Out, Relay Cable/control lines, and AC power line.Use of the filters often helps cure SWR problems between amp exciter and amp and between amp and antenna tuner or direct to antenna.The AC power line choke helps keep common mode current out of the power line which could cause interference to other devices connected to the same power line if not suppressed.

USE

Standard kit for amplifiers with single input, single output, relay keying and AC input

Deluxe Kit for amplifiers with dual inputs/outputs, frequency/keying control lines

KIT INCLUDES

Filter Type

Usage

Standard Kit

Deluxe kit

F240 Ring (1.4” ID)

RF Exciter input

1

2

Snap On (1/2” ID)

Ethernet, PTT control

2

2

Snap On (1” ID)

RF Output

1

2

Snap On (1” ID)

120/240 VAC Input

1

1

Total Filters


5

7

INSTALLATION GUIDELINES

Standard Kit - Part# RFI-LA-FLEX-1

RF Input:Ring Filter (1.4” ID) – 5-9 turns of RG-58/8X size through center

RF Output:Snap On Filter (1” ID) – 3 turns of coax cable through center

PTT Relay Cable:Snap On Filter (1/2” ID) – multiple turns through center

Ethernet Cable:Snap On Filter (1/2” ID) – multiple turns through center

AC Power:Snap On Filter (1” ID) – 3 turns of power cord through center

Deluxe Kit - Part# RFI-LA-FLEX-2

RF Input (2)Ring Filter (1.4” ID) – 5-9 turns of RG-58/8X size through center

RF Output: (2)Snap On Filter (1” ID) – 3 turns of coax cable through center

PTT Relay Cable:Snap On Filter (1/2” ID) – multiple turns through center

Ethernet Cable:Snap On Filter (1/2” ID) – multiple turns through center

AC Power:Snap On Filter (1” ID) – 3 turns of power cord through center

Also make sure you connect a good RF ground to the amplifier ground post.

12:1 Baluns are useful between 600-650 ohm balanced loads the impedance at the  end of the feed line is 600 ohms (1/2 wavelength feed line), or high impedance feeds for rhombic,  T2FD and traveling wave antennas.

12:1 Ununs are useful between coax and long wires with a load impedance near 600 ohms like a beverage antenna.  Shortwave listener antennas also can benefit with the 12:1 unun and it may provide a better match than 9:1 ununs – this means quieter noise levels and stronger signals so you can hear distance stations easier.