12:1 Baluns/Ununs

Bullet 50:450 (9:1) HF Balun, 1.8-61 MHz, 500/1500 Watts, T2FD, BBTD, ALE

Bullet-9B-500EB
$89.95
In stock
1
Product Details
Country/Region of Manufacture: USA
Type: NEW
Input ohms/Output ohms: 50 in, 450 out
Frequency Range < 2:1 SWR (MHz): 1.8-61
PEP Power Rating (watts): 500/1500
Transformer Topology: Braodband Ferrite
Hardware Type: Stainless Steel
Weight (pounds): 2
Antenna Compatability: T2FD, BBTD, ALE, Rhombic

The Bullet-9B is a multi-core balun with a compact enclosure (looks like a bullet) enclosure that is lightweight and easy to transport for your fixed/portable ALE, T2FD or BBTD antenna systems. Also useful for rhombics and other wire antennas needing balanced 450 ohm output. Halyard hoist at top of balun for convenient attachment point. Input is via SO-239 coax connector and output with side eye bolt output.Use a 500 ohm non-inductive termination resistor for the T2FD when using this balun.

This transformer requires a feed line choke to isolate the coax feed line from the antenna. A coax noise filter at the radio end of the coax is also recommended to reduce common mode noise current picked up by the coax braid.

Available in 500 watts and 1500 watt models



Remember we over engineer our products, to out perform our competition - just compare the weight of our baluns to theirs and you will know we put much more into our products so you don't have to worry about failure at a critical moment.


Save this product for later
12:1 Baluns are useful between 600-650 ohm balanced loads the impedance at the  end of the feed line is 600 ohms (1/2 wavelength feed line), or high impedance feeds for rhombic,  T2FD and traveling wave antennas.

12:1 Ununs are useful between coax and long wires with a load impedance near 600 ohms like a beverage antenna.  Shortwave listener antennas also can benefit with the 12:1 unun and it may provide a better match than 9:1 ununs – this means quieter noise levels and stronger signals so you can hear distance stations easier.