Exercise Equipment RFI Kits
Does the operation of a treadmill or your exercise equipment wipe out your radio receiver reception? We have heard cases where the treadmill from a neighbor’s house wiped out the ham radio receiver reception from 2-30 Mhz! The treadmill source was finally isolated to a variable speed motor power supply that was injecting RFI into the AC wiring of the house and the AC wiring was acting as a transmitting antenna broadcasting the signal to the entire neighborhood. The case was difficult to track down since the broadband RFI interference only occurred at 7-8 pm each nite when the neighbor used the treadmill. As with all RFI cases the sequence is similar: Find the Source, Choke the Path, Protect the Victim.
Once the source was identified, a simple solution was to choke off the transmitting antenna with a AC line choke shown below which eliminated the interference problem to the ham receiver:
Testimonials
F400-31 AC Power Cord Choke completely cured the RFI problem I had with my wife’s treadmill. Now I can hear the weak signals!
We specify impedance ratios as an output to input ratio where the output (or load) is given first and the input is given second (e.g. 100:50 (2:1) would mean a 100 ohm output and a 50 ohm input; a 25:50 (1:2) would mean a 25 ohm load and a 50 ohm input). Most all products use a 50 ohm input unless otherwise specified.
We have products that are available as kits for the do-it-yourself (DIY) person or fully assembled and tested units for the “Plug & Play” crowd.
Our impedance transformers are available using two different topologies: Binocular cores or toroid cores with multiple turns for increased effectiveness and wide band frequency transformations. We utilize single and multiple core transformers using high order windings when needed to extend product performance.
We rate the power ratings as watts PEP (Peak Envelop Power) with standard duty cycles for various modes. To determine the PEP rating required for your needs, see: Choke & Transformer Power Ratings
This website page serves as a link page to the frequency ranges of our impedance transformers configured as either baluns or ununs. You can click on a picture to go to the specific page about the products described in the picture.