High Power rated at 2KW/5KW (option) PEP (FT8 mode at 1.5KW for 5KW PEP model)
Broad frequency range of 1.8-61 MHz for < 2:1 SWR into matched load. 5KW model is 1.8-31 MHz
Compact 4" x 4" x 2" (2KW) or 4" x 4" x 2" (5KW) light weight weatherproof enclosure
Quick, easy deployment with either halyard hoist or side mounting tabs
Choice of BALUN (balanced outputs) or UNUN (unbalanced output and ground)
Model CB-2-2000 is a 2:1 (100:50) quad core balun used to translate a 50 ohm input to 100 ohms at RF power levels up to 2000 watts PEP when used with a matched load such as single band delta loop, quad or loop skywire. This assembled balun features a multi-core configuration for increased power handling and flatter frequency response to over 60 MHz. With a matched 100 ohm load the SWR over the frequency range is very consistent from 1.8-61 MHz and SWR is less than 2:1 over the range allowing easy tuning by most radio internal antenna tuners or an external tuner.
Note: CU-2-2000SO picture shown CU-1.5-1500SO product but input/output connectors are correct.
We specify impedance ratios as an output to input ratio where the output (or load) is given first and the input is given second (e.g. 100:50 (2:1) would mean a 100 ohm output and a 50 ohm input; a 25:50 (1:2) would mean a 25 ohm load and a 50 ohm input). Most all products use a 50 ohm input unless otherwise specified.
We have products that are available as kits for the do-it-yourself (DIY) person or fully assembled and tested units for the “Plug & Play” crowd.
Our impedance transformers are available using two different topologies: Binocular cores or toroid cores with multiple turns for increased effectiveness and wide band frequency transformations. We utilize single and multiple core transformers using high order windings when needed to extend product performance.
We rate the power ratings as watts PEP (Peak Envelop Power) with standard duty cycles for various modes. To determine the PEP rating required for your needs, see: Choke & Transformer Power Ratings
This website page serves as a link page to the frequency ranges of our impedance transformers configured as either baluns or ununs. You can click on a picture to go to the specific page about the products described in the picture.