Off Center Fed (OCF) Dipole Baluns

1327136775 - Off Center Fed (OCF) Dipole Baluns
+3

RG-8X Coax Jumper Cable with PL-259's on each end - 3 feet

RG-8X-3
$16.95
In stock
1
Product Details

RG-8X male to male antenna cable for ham radio, CB and Short wave listening (SWL). This cable is 50 ohm and 3 feet long double shielded with foil and braid with PL-259 connectors on each end. All the connections inside are soldered and the cable is made of copper conductors with coax having PVC jacket. RG-8X is generally good up to 1500 watts PEP at HF frequencies below 30 MHz.

Use for short jumper for Palomar Engineers Noise Filters like CMNF-500-50 or use with Simple Dipole Feed line Choke (SDFLC) to make a 10 turn feed line choke. Also useful between radio devices such as transceiver and amplifier, SWR meter, etc.

Save this product for later
Display prices in: USD

Testimonial

Hi Bob,

Radio: Flex-6700 running barefoot -10 to 100 Watts max.
Antenna: MFJ-1216 – 160/80 meter OCFD wire antenna with matching network.
Elevation: Over 60 feet AGL – fully extended.
Installed: Mid November 2013

I operate mainly on the digital modes running less than 50 Watts.  All of the sudden after a few days operating with this antenna, I start to have RFI and my radio was acting up; such as changing bands, SWR changing values, radio failures and turning off. However, when I used my Hy-Gain 18 HT vertical on the same band none of the abnormality occurred.
I contacted MFJ and confirm that what I was noticing was a failure of their “matching network” AKA balun.  They offered no solutions. Then I contacted Palomar Engineers and bought the 1:1 new toroid RF beads.  I called Palomar Engineers and I happened to talked to you directly; regarding the on going issue with the MFJ antenna. I found out that the 1:1 balun was not what I needed (I was miss-informed by MFJ that it was 1:1 matching network.)
You offered to make the required balun 4:1 and the rest is history.

Here are my findings:

  1. No more RFI displayed on the monitors.
  2. Radio not acting up or turning off.
  3. The SWR at 160/80 meter is 1.2:1
  4. No antenna tuner required.  (radio goes to Bypass automatically.)
  5. Worst SWR is on 10 meter with a 2:1 but still usable, with antenna tuner 1.5.
  6. One happy OCFD user!

Thanks to Palomar Engineers design and engineering for solving this issue.

73, Ernest – W4EG