Off Center Fed (OCF) Dipole Baluns

982840109 - Off Center Fed (OCF) Dipole Baluns
+3

AC/DC Generator RFI Noise Filter Kit - 3" ID - 2 filters

RFI-GEN-3
$74.95
In stock
1
Product Details
MPN: RFI-GEN-3
Type: New
Country/Region of Manufacture: United States
Filter Power Rating (PEP watts): power rating of cable
RFI Suppression Range (MHz): 1-300 MHz

The RFI generator kit includes 2 ring filters with 3 inch inside diameter for 2 or more turns of AC/DC generator cable at generator and another 2 or more turns through center at the end of the generator cable near the powered device. The filter near the generator isolates generator power cable and prevents it from acting as an RFI antenna (generator source) and the filter near the powered device prevents the powered device from using the generator cable as an RFI antenna.

Use 2 or more turns through the filter for higher RFI suppression than a single turn (2 turns is 4 times the suppression as 1 turn, 3 turns is 9 times a single turn, etc.)

If you have a generator cable less than 1/2" diameter, consider the RFI-GEN-1 generator filter with a 1" inside diameter.

Note: generator cable not included.

Save this product for later
Display prices in: USD

Testimonial

Hi Bob,

Radio: Flex-6700 running barefoot -10 to 100 Watts max.
Antenna: MFJ-1216 – 160/80 meter OCFD wire antenna with matching network.
Elevation: Over 60 feet AGL – fully extended.
Installed: Mid November 2013

I operate mainly on the digital modes running less than 50 Watts.  All of the sudden after a few days operating with this antenna, I start to have RFI and my radio was acting up; such as changing bands, SWR changing values, radio failures and turning off. However, when I used my Hy-Gain 18 HT vertical on the same band none of the abnormality occurred.
I contacted MFJ and confirm that what I was noticing was a failure of their “matching network” AKA balun.  They offered no solutions. Then I contacted Palomar Engineers and bought the 1:1 new toroid RF beads.  I called Palomar Engineers and I happened to talked to you directly; regarding the on going issue with the MFJ antenna. I found out that the 1:1 balun was not what I needed (I was miss-informed by MFJ that it was 1:1 matching network.)
You offered to make the required balun 4:1 and the rest is history.

Here are my findings:

  1. No more RFI displayed on the monitors.
  2. Radio not acting up or turning off.
  3. The SWR at 160/80 meter is 1.2:1
  4. No antenna tuner required.  (radio goes to Bypass automatically.)
  5. Worst SWR is on 10 meter with a 2:1 but still usable, with antenna tuner 1.5.
  6. One happy OCFD user!

Thanks to Palomar Engineers design and engineering for solving this issue.

73, Ernest – W4EG