DSL/Cable Modem/Router/Ethernet/Internet RFI Kit - 3 Filters
Use for DSL/cable modems, routers, access points, repeaters, Ethernet switches, etc.
The RFI-ROUTER-4 kit is meant to be used with a DSL Modem/Router with incoming DSL signal, up to 4 Ethernet lines and a single power DC power supply line coming into the device.Included are one snap on ferrite (3/4” hole) and two (3/4” hole) snap on split ferrite beads for the Ethernet outputs (2 per snap on using multiple turns for each cable). The additional 3/4" snap on is for the power supply line. The RFI-ROUTER-8 kit is identical but has 2 additional ferrite snap on for up to 4 additional ports,
Useful for all brands of computer equipment.4:1 impedance transformers (Baluns and Unun configurations) are available in kit form or assembled form in a weatherproof Current Unun and Balun Enclosure which we call CUBE Baluns™ and CUBE Ununs™. All 4:1 impedance transformers use ferrite cores and the kit forms can be configured as a balun with balanced output of 200 ohms or as ununs with one side grounded.
4:1 baluns are designed for 50 ohm unbalanced (coax) input to 200 ohm output (either balanced or with one side grounded).
4:1 Baluns are useful between balanced lines for center fed Zepps, Off-center fed (OCF) dipoles with coax, G5RV antennas, full wave loops, NVIS dipoles that are close to ground and have impedance levels near 200 ohms or high impedance feeds for log periodic beams.
4:1 ununs are useful between coax and vertical antennas, monopole verticals or long wires with load impedances near 200 ohms.