Feed Line Chokes for Vertical Antenna with radials/counterpoise
Feed line chokes for verticals require a special arrangement to isolate the coax feed line from the radials and ground system. Schematically, a good feed line choke for verticals with radials should be built as follows:
Our CUV-1-1500 and CUV-1-5000 feed line chokes are all internally connected to isolate the coax feed line as shown above.
Th CUV-1-1500 unun is a common mode feed line choke for vertical antennas with radials that need to be isolated from the coaxial feed line to keep common mode current from using the coaxial braid as another radial. Very effective with high choking of 1K-5K from 1.8-61 MHz and also incorporates two side studs/wingnut terminals for radial or ground connection at the antenna while isolating the coax feed line braid from the radials via the internal common mode feed line choke. Top terminal with stud/wingnut for vertical connection enclosed in a 4″ x 4″ x 2″ box..
To reduce receiver common mode noise for long runs of coax to your antenna, use a MC-1-1500 or CU-1-1500 feed line choke at the station end of the coax.
4:1 impedance transformers (Baluns and Unun configurations) are available in kit form or assembled form in a weatherproof Current Unun and Balun Enclosure which we call CUBE Baluns™ and CUBE Ununs™. All 4:1 impedance transformers use ferrite cores and the kit forms can be configured as a balun with balanced output of 200 ohms or as ununs with one side grounded.
4:1 baluns are designed for 50 ohm unbalanced (coax) input to 200 ohm output (either balanced or with one side grounded).
4:1 Baluns are useful between balanced lines for center fed Zepps, Off-center fed (OCF) dipoles with coax, G5RV antennas, full wave loops, NVIS dipoles that are close to ground and have impedance levels near 200 ohms or high impedance feeds for log periodic beams.
4:1 ununs are useful between coax and vertical antennas, monopole verticals or long wires with load impedances near 200 ohms.