Model BA-9-250 is a 9:1 balun/unun kit (assembly from parts supplied required) used to translate a 50 ohm input up to 450 ohms at RF power levels up to 250 watts PEP when used with a matched load. With a matched 450 ohm load the SWR over the frequency range 1.8 to 30 MHz is shown in the following table measured with an AIM 4170 network analyzer. Notice that the conversion from 450 to 50 ohms is very consistent from 1-31 MHz and SWR is less than 2:1 over most of the range allowing easy tuning by most radio internal antenna tuners or an external tuner. Graph is for a 9:1 unun often used with long wire or end fed antennas.
Radio Club idea:
Typical SWR curve for this project:
4:1 impedance transformers (Baluns and Unun configurations) are available in kit form or assembled form in a weatherproof Current Unun and Balun Enclosure which we call CUBE Baluns™ and CUBE Ununs™. All 4:1 impedance transformers use ferrite cores and the kit forms can be configured as a balun with balanced output of 200 ohms or as ununs with one side grounded.
4:1 baluns are designed for 50 ohm unbalanced (coax) input to 200 ohm output (either balanced or with one side grounded).
4:1 Baluns are useful between balanced lines for center fed Zepps, Off-center fed (OCF) dipoles with coax, G5RV antennas, full wave loops, NVIS dipoles that are close to ground and have impedance levels near 200 ohms or high impedance feeds for log periodic beams.
4:1 ununs are useful between coax and vertical antennas, monopole verticals or long wires with load impedances near 200 ohms.