811134926 - HF High Power Impedance Transformers

Simple Dipole Feed Line Choke - RG8X - RFI Range: 1-100 MHz

Store/RFI Solution Kits/Radio Communication RFI Solutions/Feedline Chokes & Static Bleeders

Product Details

MPN: EFFLC-240

Simple Dipole Feed Line Choke for 1/4" coax (1.8-61 MHz)

The simplest, most cost effective feed line choke is a ferrite ring installed as shown in the picture (at the antenna feed point).

Improves antenna pattern by preventing your dipole from becoming a tripole

Prevents pesky coax braid radiation and RFI

for best results use multiple turns through center

Use one choke for each antenna feed line - take a 3 foot piece of G-8X (part# RG8X-3) and wrap 10-12 turns thru center for a good feed line choke.

The high power ferrite impedance transformer series (> 1:1), configured with outputs to act as a baluns (unbalanced coax in to balanced load output) or as ununs (unbalanced coax input to unbalanced load output) are designed for demanding radio transmitter stations that run over 1,000 watts PEP or run continuous modes like AM, digital, RTTY, FM, etc. at high power levels. Radio contest operators, commercial shortwave broadcast, and industrial and commercial stations use these transformers for for a variety of balanced and unbalanced antenna loads. Baluns are typically used for balanced loads and antennas like dipoles, loops, log periodics, and direct feed yagi/beams. Ununs are used with verticals, end fed wires, horizontal dipoles, G5RV/ZS6BKW, Zepps, vertical wire beams, etc). All products are in an enclosed NEMA water resistant box with SO-239 input connector and stainless steel side/top studs with wing nuts or side and top eyebolts. The enclosure box has mounting “side feet” for attachment to a post or antenna boom using nylon ties.