HF High Power Impedance Transformers

This minicart widget's layout is unsupported in this version

Current Unun and Balun Enclosure – CUBE Chokes™ are available with balanced output (eyebolts, top or side studs - in which case they are called "baluns") or with unbalanced output (top stud and ground - in which case they are called "ununs"). We also make 1:1 Baluns in the "BULLET" round tube format which offers 100, 500, 1500 and 5000 watts sizes.

In all cases they have a 50 ohm input and a 50 ohm output and act as feed line chokes which suppress the coax braid current and thereby "balance" the current in baluns with balanced output.

CUBE baluns and ununs have higher choking impedance (better common mode rejection) than simple snap on or slip on choke types.

Refine by
 

Filters

Filters
Other cool products
Recently viewed products
The high power ferrite impedance transformer series (> 1:1), configured with outputs to act as a baluns (unbalanced coax in to balanced load output) or as ununs (unbalanced coax input to unbalanced load output) are designed for demanding radio transmitter stations that run over 1,000 watts PEP or run continuous modes like AM, digital, RTTY, FM, etc. at high power levels. Radio contest operators, commercial shortwave broadcast, and industrial and commercial stations use these transformers for for a variety of balanced and unbalanced antenna loads.  Baluns are typically used for balanced loads and antennas like dipoles, loops, log periodics, and direct feed yagi/beams.  Ununs are used  with verticals, end fed wires, horizontal dipoles, G5RV/ZS6BKW, Zepps, vertical wire beams, etc).  All products are in an enclosed NEMA water resistant box with SO-239 input connector and stainless steel side/top studs with wing nuts or side and top eyebolts.  The enclosure box has mounting “side feet” for attachment to a post or antenna boom using nylon ties.