3434555668 - HF High Power Impedance Transformers

Automotive Battery Charger RFI Kit - - 1-300 MHz RFI Suppression

Product Details

This kit suppresses EMI and RFI generated from DC battery charger such as used on automotive batteries uo to 100 amps output.

Simple snap on the ferrite suppressors (1" hole size) onto the AC input using multiple turns through the center and do the same for the DC output cables. The more turns through the center the hiogher the RFI suppression.

Simple - Effective and Low Cost solution.to suppress charger noise fed back into AC power lines acting as RFI transmitting antennas!

The high power ferrite impedance transformer series (> 1:1), configured with outputs to act as a baluns (unbalanced coax in to balanced load output) or as ununs (unbalanced coax input to unbalanced load output) are designed for demanding radio transmitter stations that run over 1,000 watts PEP or run continuous modes like AM, digital, RTTY, FM, etc. at high power levels. Radio contest operators, commercial shortwave broadcast, and industrial and commercial stations use these transformers for for a variety of balanced and unbalanced antenna loads. Baluns are typically used for balanced loads and antennas like dipoles, loops, log periodics, and direct feed yagi/beams. Ununs are used with verticals, end fed wires, horizontal dipoles, G5RV/ZS6BKW, Zepps, vertical wire beams, etc). All products are in an enclosed NEMA water resistant box with SO-239 input connector and stainless steel side/top studs with wing nuts or side and top eyebolts. The enclosure box has mounting “side feet” for attachment to a post or antenna boom using nylon ties.