Model CB-6-1500 is a 6:1 (300:50) voltage balun housed in a Nema enclosure box (4″ x 4″ x 2″) with two top studs capable of input power levels up to 1.5KW PEP/500 watts continuous when used with a matched load. The 6:1 ratio takes 50 ohms input and matches to 300 ohms balanced output from 1.8-61 MHz with SWR < 1.5:1 under matched load conditions. A great balun for windoms, OCF antennas >60 feet over ground, Hertz and folded dipole antennas, T2FD etc. Dual core, Ruthroff style balun. Choose version with side eye bolts for wire attachments for OCF dipole use.
Troubleshooter's Ferrite Pack Mix 31, 75, 61, 1/2" ID Snap-On, RFI Range 150 KHz-2000 MHz, 10 PiecesProduct DetailsMaterial: 31, 61, 75Max cable size - in/mm: .5/12.7OD (A) - in/mm: 1.22/31ID (B) - in/mm: .514/13.1Length (C) - in/mm: 1.55/5Ferrite Snap On, ID = .514in/13.1 mm, 10 Pack for troubleshooting unknown RFi frequencies
Use Mix 31 for 1-300 MHz - 4 pieces
Use Mix 61 for 200- 2000 MHz - 3 pieces
Use Mix 75 for150 KHz-10 MHz - 3 pieces
At last a troubleshooter's ferrite kit that works from 150 KHz to 2 H=GHZ. Now you can suppress RFi from unknown frequency ranges with a full spectrum of ferrite cores that have a 1/2" ID large enough for multiple turns of many common data and signal wires. Try 1 mix and see if it has an effect and if not then try another until you suppress the unknown frequencies. Or use them all to provide protection across a broad frequency range. 3 ferrite cores provide at least 500 ohms in the frequency band to give a measurable difference in RFI and noise suppression.
Square or Hex sided depending upon inventory stock
Ferrite Snap On, ID = .514in/13.1 mm, 10 Pack for troubleshooting unknown RFi frequencies
Use Mix 31 for 1-300 MHz - 4 pieces
Use Mix 61 for 200- 2000 MHz - 3 pieces
Use Mix 75 for150 KHz-10 MHz - 3 pieces
At last a troubleshooter's ferrite kit that works from 150 KHz to 2 H=GHZ. Now you can suppress RFi from unknown frequency ranges with a full spectrum of ferrite cores that have a 1/2" ID large enough for multiple turns of many common data and signal wires. Try 1 mix and see if it has an effect and if not then try another until you suppress the unknown frequencies. Or use them all to provide protection across a broad frequency range. 3 ferrite cores provide at least 500 ohms in the frequency band to give a measurable difference in RFI and noise suppression.
Square or Hex sided depending upon inventory stock