Add a ferrite filter to LED Overhead Light fixtures switching power supply to suppress ugly interference back fed into the AC power lies which act as radiating antennas and cause interference to surrounding electronic devices (yours and your neighbors)! Order 1 set for each LED light fixture.
You get a snap on filter (1/4" ID) for the AC side of the power supply.
All ballasts in a particular location must have a filter otherwise RFI may not be suppressed to a measurable value. Suppresses RFI in range of 150 KHz to 10 MHz.
TECH NOTE: You must change the dimmers (if used) to LED dimmers otherwise the dimmers may be the noise generation problem, I have heard that the LUMITRON MAESTRO PRO LED+ are very effective but expensive solutions.
Due to many requests for antenna static bleeders, we have developed a product line of static bleeders for coax and for ladder line applications. Static electricity is caused by many situations including high desert wind, atmospheric conditions, etc. You may hear static crashes or have a buildup of static electricity that my be annoying during a radio conversation and it may be harmful to solid state electronics if high voltages are present on the RF input to your equipment.
A static “Bleeder” which shorts the direct static voltage to ground while leaving the RF frequency voltage unaffected if very beneficial particularly to those operations in desert conditions where low humidity, high static buildup are quite common. The SB-1 and SB-2 coax static bleeders work on coax line and the SB-3 static bleeder is meant for ladder line.
THESE DEVICES ARE NOT FOR LIGHTNING PROTECTION AND PROVIDES NO PROTECTION FOR LIGHTNING STRIKES!!!!!
Add a ferrite filter to LED Overhead Light fixtures switching power supply to suppress ugly interference back fed into the AC power lies which act as radiating antennas and cause interference to surrounding electronic devices (yours and your neighbors)! Order 1 set for each LED light fixture.
You get a snap on filter (1/4" ID) for the AC side of the power supply.
All ballasts in a particular location must have a filter otherwise RFI may not be suppressed to a measurable value. Suppresses RFI in range of 150 KHz to 10 MHz.
TECH NOTE: You must change the dimmers (if used) to LED dimmers otherwise the dimmers may be the noise generation problem, I have heard that the LUMITRON MAESTRO PRO LED+ are very effective but expensive solutions.