This RFi kit was created to eliminate RFI issues from the excellent Heil Parametric Receive Audio System which can highly tailor audio signal from your radio to a a powered speaker or multiple headphones. However when installed near a high powered HF antenna it can ave RFi issues. This kit was created out of necessity from a ham using high power antennas near the radio. The use of the ferrite filters completely eliminated the RFI issue allowing the ham to enjoy the use of the PRAS.
The ferrite filters are selected to suppress RFI from 1 to 300 MHz. The filters are easy to install, don’t require modification of the protected equipment and work in almost all cases. See product picture for suggested filter use.
What is included in the kit?
The RFI-PRAS kit contains a a ring filter for the AC power cord used on the DC supply cables to the PRAS and high powered speakerr and 3 additional snap-on filters for the both ends of the speaker cable and for the audio input (from the transceiver/audio source) to the PRAS..
You get 1 ring filter and 5 1/2" ID snap on filters and an installation manual.
Due to many requests for antenna static bleeders, we have developed a product line of static bleeders for coax and for ladder line applications. Static electricity is caused by many situations including high desert wind, atmospheric conditions, etc. You may hear static crashes or have a buildup of static electricity that my be annoying during a radio conversation and it may be harmful to solid state electronics if high voltages are present on the RF input to your equipment.
A static “Bleeder” which shorts the direct static voltage to ground while leaving the RF frequency voltage unaffected if very beneficial particularly to those operations in desert conditions where low humidity, high static buildup are quite common. The SB-1 and SB-2 coax static bleeders work on coax line and the SB-3 static bleeder is meant for ladder line.
THESE DEVICES ARE NOT FOR LIGHTNING PROTECTION AND PROVIDES NO PROTECTION FOR LIGHTNING STRIKES!!!!!
This RFi kit was created to eliminate RFI issues from the excellent Heil Parametric Receive Audio System which can highly tailor audio signal from your radio to a a powered speaker or multiple headphones. However when installed near a high powered HF antenna it can ave RFi issues. This kit was created out of necessity from a ham using high power antennas near the radio. The use of the ferrite filters completely eliminated the RFI issue allowing the ham to enjoy the use of the PRAS.
The ferrite filters are selected to suppress RFI from 1 to 300 MHz. The filters are easy to install, don’t require modification of the protected equipment and work in almost all cases. See product picture for suggested filter use.
What is included in the kit?
The RFI-PRAS kit contains a a ring filter for the AC power cord used on the DC supply cables to the PRAS and high powered speakerr and 3 additional snap-on filters for the both ends of the speaker cable and for the audio input (from the transceiver/audio source) to the PRAS..
You get 1 ring filter and 5 1/2" ID snap on filters and an installation manual.