PURPOSE
These kits are designed to choke common mode currents going into or exiting from your amplifier cables.Filters are supplied for the RF In, RF Out, Relay Cable/control lines, remote control unit and AC power line.Use of the filters often helps cure SWR problems between amp exciter and amp and between amp and antenna tuner or direct to antenna.The AC power line choke helps keep common mode current out of the power line which could cause interference to other devices connected to the same power line if not suppressed.
USE
KIT INCLUDES
|
Filter Type |
Usage |
Ferrites |
|
F240 Ring (1.4” ID) |
Transceiver RF coaxr |
1 |
|
Snap On (1/2” ID) |
Remote Control Unit cables |
5 |
|
Snap On (1” ID) |
RF Output, AC/DC power |
2 |
|
Total Filters |
8 |
INSTALLATION GUIDELINES
Amp RF Input:Ring Filter (1.4” ID) – 5-9 turns of RG-58/8X size through center
Amp RF Output:Snap On Filter (1” ID) – 3 turns of coax cable through center
RCU Cables:Snap On Filter (1/2” ID) – multiple turns through center
AC Power:Snap On Filter (1” ID) – 3 turns of power cord through center
Due to many requests for antenna static bleeders, we have developed a product line of static bleeders for coax and for ladder line applications. Static electricity is caused by many situations including high desert wind, atmospheric conditions, etc. You may hear static crashes or have a buildup of static electricity that my be annoying during a radio conversation and it may be harmful to solid state electronics if high voltages are present on the RF input to your equipment.
A static “Bleeder” which shorts the direct static voltage to ground while leaving the RF frequency voltage unaffected if very beneficial particularly to those operations in desert conditions where low humidity, high static buildup are quite common. The SB-1 and SB-2 coax static bleeders work on coax line and the SB-3 static bleeder is meant for ladder line.
THESE DEVICES ARE NOT FOR LIGHTNING PROTECTION AND PROVIDES NO PROTECTION FOR LIGHTNING STRIKES!!!!!
PURPOSE
These kits are designed to choke common mode currents going into or exiting from your amplifier cables.Filters are supplied for the RF In, RF Out, Relay Cable/control lines, remote control unit and AC power line.Use of the filters often helps cure SWR problems between amp exciter and amp and between amp and antenna tuner or direct to antenna.The AC power line choke helps keep common mode current out of the power line which could cause interference to other devices connected to the same power line if not suppressed.
USE
KIT INCLUDES
|
Filter Type |
Usage |
Ferrites |
|
F240 Ring (1.4” ID) |
Transceiver RF coaxr |
1 |
|
Snap On (1/2” ID) |
Remote Control Unit cables |
5 |
|
Snap On (1” ID) |
RF Output, AC/DC power |
2 |
|
Total Filters |
8 |
INSTALLATION GUIDELINES
Amp RF Input:Ring Filter (1.4” ID) – 5-9 turns of RG-58/8X size through center
Amp RF Output:Snap On Filter (1” ID) – 3 turns of coax cable through center
RCU Cables:Snap On Filter (1/2” ID) – multiple turns through center
AC Power:Snap On Filter (1” ID) – 3 turns of power cord through center