Model CB-9-5000 is a 9:1 multi-core, balanced output balun housed in a NEMA enclosure box (4″ x 4″ x 2″) with top studs (TS) used to translate a 50 ohm input up to 450 ohms at RF power levels up to 5000 watts PEP when used with a matched load. With matched 450 ohm load the SWR over the frequency range 1 to 31 MHz is less than 2:1 on the coax feed side.
All power rating are PEP, 100%, continuous digital modes are 30% duty factor rating of PEP, FT-8 digital mode rated at 1500 watts.
Application note: If using 450 ohm ladder line on the output of the balun top studs, make sure the impedance seen at the balun end of the ladder line is near 450 ohms since the ladder line acts as an impedance transformer, the impedance at the end of the ladder line may be different than the characteristic 450 ohms of the ladder line. For example a 1/4 wavelength of ladder line will transform a high impedance at the antenna feed point to a very low impedance at the other end connected to the balun thus placing a very low impedance load on a balun expecting 450 ohms and such a load may damage the balun. The impedance seen at the balun output should be near 450 ohms for full power rating.
Due to many requests for antenna static bleeders, we have developed a product line of static bleeders for coax and for ladder line applications. Static electricity is caused by many situations including high desert wind, atmospheric conditions, etc. You may hear static crashes or have a buildup of static electricity that my be annoying during a radio conversation and it may be harmful to solid state electronics if high voltages are present on the RF input to your equipment.
A static “Bleeder” which shorts the direct static voltage to ground while leaving the RF frequency voltage unaffected if very beneficial particularly to those operations in desert conditions where low humidity, high static buildup are quite common. The SB-1 and SB-2 coax static bleeders work on coax line and the SB-3 static bleeder is meant for ladder line.
THESE DEVICES ARE NOT FOR LIGHTNING PROTECTION AND PROVIDES NO PROTECTION FOR LIGHTNING STRIKES!!!!!
Model CB-9-5000 is a 9:1 multi-core, balanced output balun housed in a NEMA enclosure box (4″ x 4″ x 2″) with top studs (TS) used to translate a 50 ohm input up to 450 ohms at RF power levels up to 5000 watts PEP when used with a matched load. With matched 450 ohm load the SWR over the frequency range 1 to 31 MHz is less than 2:1 on the coax feed side.
All power rating are PEP, 100%, continuous digital modes are 30% duty factor rating of PEP, FT-8 digital mode rated at 1500 watts.
Application note: If using 450 ohm ladder line on the output of the balun top studs, make sure the impedance seen at the balun end of the ladder line is near 450 ohms since the ladder line acts as an impedance transformer, the impedance at the end of the ladder line may be different than the characteristic 450 ohms of the ladder line. For example a 1/4 wavelength of ladder line will transform a high impedance at the antenna feed point to a very low impedance at the other end connected to the balun thus placing a very low impedance load on a balun expecting 450 ohms and such a load may damage the balun. The impedance seen at the balun output should be near 450 ohms for full power rating.